
Viewing 3D images
■Replacing the battery
When the battery is running low, the indicator lamp flashes 5 times on turning the 3D Eyewear on. In this case, early battery replacement is recommended.
•Dispose of the old batteries as Loosen the screw and remove the battery cover using the supplied screwdriver
Screwdriver (supplied)
Battery cover
Replace the battery
• Use the specified type of battery
•Note the correct polarity (+ or
Replace and fasten the battery cover
Battery cover
■Attaching the nose pad
• Make sure that the screw is tightened.
Use either nose pad A or B for your preference.
• If you put the 3D Eyewear on vision correction glasses, the nose pad is recommended to be removed.
| • You can select the positions of the nose pad A from the 2 levels of height. |
Nose pad A | Use upper 2 protrusions or lower 2 protrusions on the 3D Eyewear to attach |
| the nose pad A. |
or | • Use all 3 protrusions on the 3D Eyewear to attach the nose pad B. |
Push to adjust the length of the band
When the end of the specialised band is straightened, form a loop at the end of the band, and fix the twisted part.
Fix the twisted part
• Treat the rubber part carefully not to break it.
■Storing and cleaning the 3D Eyewear
•Use the supplied 3D Eyewear case to store the 3D Eyewear.
•Avoid storing the 3D Eyewear in hot or highly humid locations.
•Use a clean, soft and dry cloth to wipe the 3D Eyewear. Otherwise, dirt or dust may scratch the eyewear.
•Do not use benzene, thinner, or wax on the 3D Eyewear, as doing so may cause the paint to peel off.
•Do not submerge the 3D Eyewear in liquid such as water when cleaning.
24