
Adjusting POS. /SIZE
● OVER SCAN Turn image over scan ON/OFF. Configurable signals are as follows:
525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, RGB, DVI, SDI, HDMI)
ONOFF
Notes:
•When “OFF” is set,
•When the “UNDER SCAN” is set to “ON”, this setting will be invalid.
●CLAMP POSITION (During Component and RGB input signal)
Adjusts the clamp position when black parts of the image have no detail due to underexposure or are tinged with green.
Optimum value for Clamp Position adjustment
When black parts have no detail due to underexposure (blackout) →Value that causes least blackout is the optimum.
When black parts are tinged with green
→Value that cancels the greenishness without causing blackout is the optimum.
●1:1 PIXEL MODE Adjusts the display size when 1125i, 1125p or 1250i signal is input.
Notes:
•Select ON when you would like to replay 1920 × 1080 input signal.
•Applicable input signal;
1125 (1080) / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p, 1250 (1080) / 50i
•Select OFF when flickering is shown around the image.
•
●1:1 PIXEL MODE (2k1k) (For 2k1k signals)
OFFON
When the input signal is a 2k1k signal (2048×1080 / 24p, 2048×1080 / 24sF), the display size is adjusted as follows.
OFF | ON (LEFT) | ON (CENTER) | ON (RIGHT) |
Note:
2k1k signals can only be received when the Dual Link
●UNDER SCAN Adjusts the image display size on screen.
OFF: Sets the normal image display size on screen.
ON: Sets the image display size approximately 95 % of the normal image display.
OFFON
Notes:
•“UNDER SCAN” can be modified when “Studio mode” in the OPTIONS menu is “On”. When “Studio mode” is “Off”, this setting is “OFF” and cannot be changed. (see page 56)
•This setting is valid only when the input signals are as follows;
525i, 525p, 625i, 625p, 750/60p, 750/50p, 1125/60i, 1125/50i, 1125/24sF, 1125/25p, 1125/24p, 1125/30p, 1125/60p, 1125/50p, 1250/50i (Component Video, RGB, DVI, SDI, HDMI)
•When “UNDER SCAN” is set to “ON”,
•Refer to each board’s operating instruction for DVI, SDI’s corresponding signals.
30