Network Setup

Make the various settings to use the network function.

3D SETTINGS

SIGNAL

SCREENSAVER

EXTENDED LIFE SETTINGS

INPUT LABEL

NETWORK SETUP COMPONENT/RGB-IN SELECT

RGB

2 access

1 select

DHCP, IP ADDRESS, SUBNET MASK, and GATEWAY settings

1 Set DHCP.

When “OFF” is selected, IP ADDRESS and other settings can be set manually.

2 Select the item and press .

3 Enter an address.

IP ADDRESS

1 Use

to select a digit.

I192.168. 0. 8

2Use to change a number or input the numerical value from to .

3Press .

NETWORK SETUP

 

 

 

 

 

SAVE

 

 

 

 

 

 

 

 

 

 

 

DHCP

 

OFF

 

 

 

IP ADDRESS

 

 

 

 

 

 

192.168.

0.

8

 

 

 

SUBNET MASK

 

 

 

 

255.255.255.

0

 

 

 

 

 

 

GATEWAY

 

192.168.

0.

1

 

 

 

Pressing will cancel the address change. 4 Select “SAVE” and press .

PORT setting

1 Select “PORT” and press . 2 Enter a port number.

PORT

 

PORT

1024

I01024

 

 

LAN SPEED

AUTO

 

 

 

 

NETWORK ID

0

 

 

 

 

CONTROL I/F SELECT

RS-232C

 

MAC ADDRESS

--:--:--:--:--:--

 

SAVE

Save the current network Setup. Each value set for DHCP, IP address, Subnet mask, and Gateway will be saved. If “NG” is displayed, check the same IP address is not used within the same network.

DHCP (DHCP client function)

To obtain an IP address automatically using a DHCP server, set this to “ON”. If DHCP server is not used, set this to “OFF”.

IP ADDRESS (IP address display and setting)

Enter an IP address if DHCP server is not used.

SUBNET MASK (Subnet mask display and setting)

Enter a subnet mask if DHCP server is not used.

GATEWAY (Gateway address display and setting) Enter a gateway address if DHCP server is not used.

1Use to select a digit.

2Use to change a number or input the numerical value from to .

3Press .

Pressing will cancel the port number change.

PORT

Set the port number used for command control. The available setting range is 1024 – 65535.

When the PJLink™ protocol is used, the port setting is not necessary.

LAN SPEED

Set the connection speed of the LAN environment.

Select the value from Auto, 10 Half, 10 Full, 100 Half or 100 Full.

NETWORK ID

Set the ID to identify this unit.

The available setting range is 0 – 99.

CONTROL I/F SELECT

Set whether to control with RS-232C (serial) or LAN. When “LAN” is set, power is supplied to LAN circuit, and power indicator is lit orange under the condition of power off with remote control (stand-by state).

MAC ADDRESS

Display the MAC address of this unit. However, the MAC address is not displayed when the “CONTROL I/F SELECT” is set to “RS-232C”.

Notes:

•To use a DHCP server, make sure the DHCP server is started.

•Contact your network administrator for details on settings.

55