Connections
PC Input Terminals connection(Female)
COMPUTER
Audio | Stereo mini plug (M3) |
|
Connect a cable which matches
the audio output terminal on the computer.
Conversion adapter
(if necessary)
Mini
RGB
PC cable
(Male)
Notes:
•With regard to the typical PC input signals that are described in the applicable input signals list (see page 65), adjustment values such as for the standard picture positions and sizes have already been stored in this unit. You can add up to eight PC input signal types that are not included in the list.
•Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
•The display resolution is a maximum of 1,440 × 1,080 dots when the aspect mode is set to “4:3”, and 1,920 × 1,080 dots when the aspect mode is set to “FULL”. If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.
•The PC input terminals are
•Some PC models cannot be connected to the set.
•There is no need to use an adapter for computers with DOS/V compatible Mini
•The computer shown in the illustration is for example purposes only.
•Additional equipment and cables shown are not supplied with this set.
•Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified frequency range.
•Component Input is possible with the pin 1, 2, 3 of the Mini
•Change the
5 |
| 4 | 3 | 2 |
| 1 |
10 | 9 |
| 8 | 7 | 6 | |
15 | 14 | 13 | 12 |
| 11 | |
Pin Layout for PC Input Terminal
Pin No. | Signal Name | Pin No. | Signal Name | Pin No. | Signal Name |
1 | R (PR/CR) | 6 | GND (Ground) | 11 | NC (not connected) |
2 | G (Y) | 7 | GND (Ground) | 12 | SDA |
3 | B (PB/CB) | 8 | GND (Ground) | 13 | HD/SYNC |
4 | NC (not connected) | 9 | +5 V DC | 14 | VD |
5 | GND (Ground) | 10 | GND (Ground) | 15 | SCL |
15