Display
Messages
Major confirmation/error messages to be indicated on the screen in text.
CHECK CARD.
This card is not compatible or it cannot be recognized by the unit.
If this message appears even though motion pictures and still pictures are recorded on an SD card, the card may be unstable. Reinsert the SD card, then turn the unit off and then on again.
INVALID/CANNOT SET.
Since there is a condition to use the function, it is required to cancel/change other settings.
Others
Troubleshooting
∫It is not a malfunction in following cases
The lens or LCD monitor | ≥ This is due to condensation. It is not a breakdown. Please refer |
fog up. | to page 2. |
A clicking sound is heard ≥ This is the sound of the lens moving and is not a defect.
when the unit is shaken. This sound will no longer be heard when the unit is turned on
and change the mode to 
.
Object seems to be warped. ≥ Object seems to be warped slightly when the object moves across the image very fast, but this is because the unit is using MOS for the image sensor. This is not a malfunction.
Power
Problem | Check points |
This unit cannot be turned ≥ Charge the battery again to ensure it is sufficiently charged. | |
on. | (l 12) |
≥In cold places, the battery using time becomes shorter.
This unit does not stay on ≥ The battery has a limited life. If the operating time is still too
long enough. | short even after the battery is fully charged, the battery has |
Battery runs down quickly. | worn out and needs to be replaced. |
| |
|
|
This unit cannot be | ≥ Remove the battery or AC adaptor, wait about 1 minute and |
operated though it is | then reconnect the battery or AC adaptor. Then about |
turned on. | 1 minute later, turn on the unit again. (Conducting the above |
| operation while the media is being accessed may damage the |
This unit does not operate | data on the media.) |
normally. | ≥ If normal operation is still not restored, detach the power |
| connected, and consult the dealer who you purchased this |
| unit from. |
