Panasonic AG-HMR10P SD Memory Cards

Inserting and removing SD Memory Cards

1 Open the SD card cover.

2 Slide the card slot cover open button to the left to open the card slot cover.

•Recording stops if the card slot cover is opened during recording.

3 Insert or remove the SD Memory Card.

•Before removing the SD Memory Card, ensure that the SD Memory Card access lamp is not flashing orange.

SD Memory Card access lamp

LOCK

To insert: Insert the card with the label facing up, and push until it clicks firmly into place.

To remove: Press the center of the SD Memory Card so that it pops out slightly, and then pull the card straight outwards.

•Do not remove the SD Memory Card or switch off the power in the following circumstances. Doing so may damage your SD Memory Card.

1)While the SD Memory Card access lamp is still flashing orange after an SD Memory Card has been inserted.

2)While the SD Memory Card access lamp is flashing, such as during recording or during recording finalization.

4 Close the card slot cover by pressing it up with your finger.

• Ensure that the cover firmly clicks into place.

5 Close the SD card cover.

	• Always format SD Memory Cards that have
	been used in other devices when first using
	them with this portable recorder. (Page 34)
	• If the system frequency of the portable
	recorder is changed, it will not be possible to
	use an SD Memory Card. Before using a card,
	format it with the current system frequency
	settings.
	• When a card is formatted, all of its recorded
	data will be erased, and it will not be
	subsequently possible to restore this data.	Preparation
	Save any valuable data onto your computer or
	other storage media prior to formatting.
	other storage media prior to formatting.
	• If “CHECK CARD” is displayed on the LCD
	monitor screen, remove the SD Memory Card
	and insert it again.

Protecting SD Memory Cards

Move the write-protect switch on the SD Memory Card to the “LOCK” position to prevent recorded contents being accidentally erased from the card.

LOCK