Panasonic AG-HMR10P Setting the time code

Setting the time code

Setting the time code

In the [TC/UB SETUP] setup menu, set the following time code related items. (Page 86)

•TC MODE

(Only when [SYSTEM FREQ] is set to [59.9Hz])

•TCG

•SDI REGEN

•TC PRESET

When [SDI REGEN] is set to [ON],

the [TC MODE], [TCG] and [TC PRESET] settings cannot be changed.

Specifying the time code (TC PRESET)

Set [TC PRESET] to record a value of your choice as the initial time code setting to be used at the start of recording.

1 Press the portable recorder’s [POWER] button for 2 seconds or longer to turn on the power.

2 Press the [MENU] button. Using the setup menus (Page 29)

3 Select [TC/UB SETUP] → [TC PRESET].

5 When the screen below appears, set the time code value.

Press to select the time code value.

Press to move to the next digit, and then

press again to select the value.

Hour

Minute

Second

Frame

Example: To set 10 hours, 23 minutes, 46 seconds, frame 20, select the time code value “10h23m46s20f.”

Press the [USER] button while setting the time code to reset the time code to zero.

6 Press the [ENTER] button when you have finished setting the time code.

7 Press to move to [YES], and then press the [ENTER] button.

Recording

4 Press to move to [YES], and then press the [ENTER] button.

With this portable recorder, the time code value is adjusted in accordance with the recording format and frame rate. When shooting is performed with the recording format set to 1080/24P or 720/24P, recording is performed 4 frames at a time. For this reason, if you change the recording format or frame rate, it may result in discontinuity from the last time code value of the previous recording. (Only when [SYSTEM FREQ] is set to [59.9Hz])

39