Panasonic AG-HPX170P Editing the recorded clip metadata, Slot total, Press the Operation lever

3P2 card remaining memory/total memory The P2 card’s remaining memory and total memory are displayed here in 1-minute increments. Fractions of a minute are rounded off, meaning the display may not match the slot total.

4Card warning mark

This mark is displayed when one of the following warnings applies to a P2 card.

1)RUN DOWN CARD (Page 91)

2)DIR ENTRY NG CARD (Page 91)

•The contents of the warning can be viewed by checking the card information as described above.

5Slot total

The figure represents the total remaining memory of the cards in the two slots. If a P2 card is write-protected, its remaining memory will not be included in the total remaining memory.

•When LOOP is set under REC FUNCTION, the slot total represents the standard recording time for loop recording.

However, note that when PROPERTY SETUP: USED is selected in step 3 on the previous page, the used amount displayed by the slot total will be larger than the actual amount, and when PROPERTY SETUP:

REMAIN is selected, the remaining amount displayed by the slot total will be smaller than the actual amount. (Page 47)

SD memory card information screen

SD STANDARD: This indicates whether the SD memory card was formatted in compliance with the SD or SDHC standard. (SUPPORTED/NOT SUPPORTED).

USED: Space used

BLANK: Space available

TOTAL: Total space

NUMBER OF CLIPS: Number of clips

PROTECT: This indicates that the SD memory card is writeprotected.

Editing the recorded clip metadata

1 On the clip information screen, display the detailed clip metadata screen.

2 Use the Operation lever to move the cursor to the item to be edited.

Metadata that can be edited, such as “USER CLIP NAME”, is displayed as shown in the following example.

Playback

3 Press the Operation lever.

The metadata editing screen (on-screen keyboard) is displayed.

Enter characters using the on-screen keyboard to edit the metadata.

4 Press the “OK” button on the on-screen keyboard.

The edited metadata is written to the clip, and the detailed clip metadata screen returns.

(Continued on the next page)

71