Panasonic AJ-D910WBP operating instructions 149

Warning System

If trouble is detected immediately after the power is turned on or during operation, the display window (LCD), WARNING lamp, lamps inside the viewfinder, and warning tones from the speaker and earphone inform the operator of trouble.

	Display window (LCD)				Lamps
		Warning	Remain-	Remain-	WARN-		Warning	Warning	VTR (section)
Item	Warning		ing	ing tape		REC	tone	contents	operation	Countermeasures
	display	display	battery	length	ING	lamp
		status	level		lamp
				display
			display
									Head clogging is
									detected and a
									warning tone
									emitted. Images	Clean the heads.
							Emitted		may not be	If images still
					Flashes	Flashes		Video head	recorded properly.	cannot be
							4 times
		Flashes			4 times	4 times		clogging,	RF flashing status	recorded properly
RF	RF						per
		F1)			per	per		recording	can be held until	after the heads
							second
					second	second		system trouble	REC/PAUSE	are cleaned,
							F1)
									mode is activated,	consult your
									and it goes off	dealer.
									when REC/
									PAUSE mode is
									released.
										Turn off the power
										and consult your
					Flashes	Flashes	Emitted		Recording	dealer. (Lamps
									continues, but	may flash briefly
					4 times	4 times	4 times	The servo is
SERVO	SERVO	Lighted							images may not	and then go off
					per	per	per	out of order.
									be recorded	when tape running
					second	second	second
									properly.	starts, but this
										does not indicate
										trouble.)
							Emitted		Recording	If tape running
							4 times			stops and the
									continues, but
							per			HUMID display
						Flashes			stops if tape
							second			does not go off
						4 times			sticking occurs.
HUMID	HUMID	Lighted			Lighted		F1)	Condensation		even when the
						per			Playback, fast	power is turned off
						second	Continu-		forward and
										and then on again,
							ous		rewind operation
										wait until the
							tone F2)		stops.
										display goes off.
									An error code	Check the error
									appears in the
					Flashes	Flashes				code in the display
							Continu-		time code display
SLACK	SLACK	Flashes			4 times	4 times		Tape wind-up		window (see
					per	per	ous	trouble	position of the	page 151) and
							tone		display window
					second	second				consult your
									(LCD) and the
										dealer.
									VTR stops.
F1) During recording
F2) During playback, fast forward or rewind

Note{

If a cleaning tape is not available to deal with video head clogging, etc., first estab- lish the STOP mode and then press the STOP button again while the RESET but- ton on the side panel is kept depressed. While these buttons are held down, the cleaning roller will clean the heads for a maximum of 10 seconds.

– 149 –