Installation

(The installation work must be performed by your dealer without fail.)

$Installing the pan-tilt head

Be absolutely sure to follow the instructions below when installing the pan-tilt head. Failure to do so may cause the pan-tilt head to slip out of position or fall.

O Make sure that the installation of the pan-tilt head has been completed before mounting the camera onto it.

O To mount the pan-tilt head, use the four mounting holes and secure it firmly in place. O Have M6 hexagonal bolts ready as these must be used for mounting the pan-tilt head. O The hexagonal bolts must be long enough to meet the requirement of “mounting

material thickness (t) plus 25 mm or longer.”

O Use flat washers, spring washers and hexagonal nuts with the hexagonal bolts, as shown in the figure.

O Use a wrench that fits the size of hexagonal bolt heads to tighten the hexagonal bolts. O For suspended installation, pass a wire through the safety wire mounting hole, and

fasten it securely to the ceiling or other structurally sound object.

O Have a wire ready which is strong enough to bear the weight of the entire pan-tilt head system (pan-tilt head, camera, lens and cable).

O Install the pan-tilt head so as to ensure that none of the components mounted on the pan-tilt head or cables will come into contact with any objects in the vicinity when the pan-tilt head rotates.

<Note>

When installing the pan-tilt head, refrain from forcibly turning the head or tilting arm by hand.

Doing so may cause the unit to malfunction.

t

t

Safety wire

13