Connections

$Connecting the AC adapter for use with the pan-tilt head

Connect the pan-tilt head with the AW-PS300 AC adapter designed for use with the pan- tilt head.

 

 

ND/EXT

 

 

 

IN

 

 

 

SDI

 

LENSEI/FCAMERAI/F

 

CONTROL IN

DC12V

LAMP

1394

IN

CONTROL

IP/RP

+ - C S OP

G/L I N

Pb OUT

Pr /SDI

Y/VIDEO

 

 

OUT

OUT

<

;

=Approx. 1 cm

It is recommended that the tip be soldered.

AC adapter for use with the pan-tilt head:

AW-PS300

;DC 12V IN terminal board

Connect this to the DC 15V OUT connector on the AC adapter (AW- PS300). (The voltage output from the AC adapter is set to 15V: this takes into consideration the voltage drops due to the possible extension of the DC cable between the pan-tilt head and AC adapter.)

Make sure that the positive + and negative - ends of the wires are connected to the same signs on the connector.

Use a cable with a nominal cross section of 1.25 mm2 or more which complies with the Electrical Appliance and Material Control Law for the connection.

Use a cable with a nominal cross section of 0.3 mm2 or more that complies with the Electrical Appliance and Material Control Law for the connection.

=OP terminal board

Connect this only when the OP SW CONTROL OUT connector on the AC adapter (AW-PS300) is to be used.

Connect it to the OPTION SW CONTROL IN connector on the AC adapter (AW-PS300).

Use a cable with a nominal cross section of 0.3 mm2 or more that complies with the Electrical Appliance and Material Control Law for the connection.

<LAMP CONTROL terminal board Connect this only when the power of a halogen lamp is to be supplied from the LAMP AC OUT connector on the AC adapter (AW-PS300).

This connector is connected to LAMP CONTROL on the AC adapter for the pan-tilt head.

The symbols C and S on the wires must match the same symbols on the connector.

21