Operation
Turning on the power
1.Set all the power switches of the connected components and the power switch of the AC adapter to ON.
2.Set this unit’s OPERATE switch to ON.
Power will be supplied to the pan/tilt head system connected to this unit, and the camera’s initial settings will be performed in sequence.
It takes about 5 seconds to perform the camera’s initial settings for each camera. The pan/tilt head system cannot be controlled until these settings are completed.
Be sure to set power switches on all connected equipment and AC adapters to ON before setting the control panel’s OPERATE switch to ON.
When the pan/tilt head system is connected (or changed) and its power is turned on for the first time, the connected cameras will be initialized. Upon completion of the initialization, adjust or set the following items. After the items are adjusted or set, proceed to the section entitled “Setting the travel range (limiters) of the pan/tilt head”.
Once the adjustments are made, there is no need for any
EXTERNAL CONTROL OUT setting
Set this to ON when connecting the
1.Press the LAMP button while holding down the MEMORY button.
2.The LAMP button’s lamp starts flashing, and the standby status is established.
3.Press the LAMP button to establish the setting mode. The lamps of both the MEMORY button and LAMP button start flashing, and the status currently set is indicated as follows:
When the PRESET 5 button lamp is lighted:
EXTERNAL CONTROL OUT ON
When the PRESET 10 button lamp is lighted:
EXTERNAL CONTROL OUT OFF
4.Press the PRESET 5 button to set to EXTERNAL CONTROL OUT ON.
Press the PRESET 10 button to set to EXTERNAL CONTROL OUT OFF.
The lamps of both the MEMORY button and LAMP button stop flashing, and the setting mode is exited.
18
