Panasonic AW-RP555N manual  Shutter button,  White BAL A/B/ATW buttons

Parts and their functions

			GAIN	AUTO	WHT BAL
OPERATE				MANU	A
				0dB
				L
		CAM	MODE	H	B
ON				BAR
		CONT		CAM
		ON	SHUTTER		ATW
OFF
		OFF
		TALLY
	2	3	4	5	1
		CONTROL
1	2	3	4	5
LEVEL	IRIS		MEMORY		6
			AUTO
			MANU

Multi Hybrid Control Panel AW-RP555

AWC	SCENE FILE
		USER
NG		1
OK				MENU
		2
ABC			MENU ITEM		YES	NO
		3
	PRESET			DEF	WIP	H/F
2	3	4	5

(AF)

EXT ND OP

7 8 9 10

LAMP

SPEED		ZOOM
LOW	TELE
HIGH
	WIDE

FAR

NEAR

FOCUSPAN/TILT

UP

LEFTRIGHT

DOWN

SHUTTER button

This is used to select the shutter speed of the camera in the pan/tilt head system currently selected.

Each time the button is pressed, the set shutter speed is switched to shutter OFF or vice versa.

The shutter speed is actually switched as soon as the button is released.

At any setting except OFF, the button’s lamp lights; at the OFF setting, it is off.

[How to register the shutter speed]

1.Press the SHUTTER button while holding down the MEMORY button.

2.The PRESET [1 to 5] buttons and PRESET [6 to 10] buttons start flashing alternately.

3.Press the PRESET button that corresponds to the shutter speed to be registered.

The table below lists the shutter speeds which can be set.

1/100	PRESET 1	1/4000	PRESET 6
1/250	PRESET 2	1/10000	PRESET 7
1/500	PRESET 3	SYNCRO-SCAN	PRESET 8
1/1000	PRESET 4	ELC	PRESET 9
1/2000	PRESET 5	OFF	PRESET 10

When OFF is set, the shutter will not be operated even when the SHUTTER button is pressed. Select the SYNCRO-SCAN setting from the camera menu.

The change in the shutter speed is reflected when the shutter is next set to ON.

This setting is retained in the memory even after the control panel’s power has been turned off.

[When temporarily changing the shutter speed without registering it]

Press the PRESET button corresponding to the shutter speed to be set while holding down the SHUTTER button. Refer to the table above for the shutter speeds which can be set.

The shutter speed will be changed as soon as the PRESET button is pressed.

This setting will be cleared when either the shutter button is pressed or the camera’s power is turned off.

WHITE BAL [A/B/ATW] buttons

These are used to select the camera’s white balance adjustment in the pan/tilt head system currently selected.

A:When the A button is pressed, the white balance status entered in the camera’s memory A is established, and the A button’s lamp comes on. If the AWC button is pressed after the A button was pressed, the white balance is automatically adjusted and entered in the camera’s memory A.

B:When the B button is pressed, the white balance status entered in the camera’s memory B is established, and the B button’s lamp comes on. If the AWC button is pressed after the B button was pressed, the white balance is automatically adjusted and entered in the camera’s memory B.

ATW: When the ATW button is pressed, the white balance is set to the automatic adjustment mode, and the ATW button’s lamp comes on.

6