How to change the position of the connector panel
The position of the connector panel can be changed from the rear panel to the bottom panel.
Before changing the position, turn off the power.
Remove the four bottom panel screws, and remove the blank panel.
Remove the blank panel.
Screws × 4 (bottom panel)
Remove the four rear panel screws, and remove the connector panel.
Secure the blank panel to the rear panel using the screws.
Remove the two rubber feet from the blank panel.
Secure the connector panel to the bottom panel using the screws.
Remove the connector panel. | Screws × 4 (rear panel) |
| |
TALLY5 |
|
TALLY3 |
|
TALLY1 |
|
TALLY2 | DC12V IN |
TALLY4 | |
TALLY IN TALLY GND | GND |
TO PAN/TILT HEAD | MONITOR SELECT |
|
R | S |
|
|
|
|
REMOTE/SERVICE | 5 | 4 | 3 | 2 | 1/EXT |
Screws × 4 (rear panel)
Blank panel
Remove the two rubber feet.
Connector panel | Screws × 4 (bottom panel) |
| |
TALLY5 |
|
TALLY3 |
|
TALLY1 |
|
TALLY2 | DC12V IN |
TALLY4 | |
TALLY IN TALLY GND | GND |
TO PAN/TILT HEAD | MONITOR SELECT |
R | S |
|
|
|
|
REMOTE/SERVICE | 5 | 4 | 3 | 2 | 1/EXT |
27
