Panasonic AW-RP555N manual Preset memory settings, Pan/tilt head system’s settings, Camera

Operation

Preset memory settings

The multi hybrid control panel is equipped with a preset memory function for entering the positions and settings with which the pan/tilt head system is to shoot.

Preset memory data is entered into PRESET buttons 1 through 10.

Pan/tilt head system’s settings

Pan/tilt head:

Pan/tilt position

Camera:

Zoom, focus, iris (MANU mode only), white balance

Entering preset memory data

1.	Select the pan/tilt head system using the CONTROL
	button.
2.	Use the following buttons to establish the modes.
	 Press the IRIS button to establish the MANU mode
	(the IRIS button’s lamp now goes off).
	If the AUTO mode is established, the lens iris position
	will not be entered.

			GAIN	AUTO	WHT BAL
OPERATE				MANU	A
				0dB
				L
		CAM	MODE	H	B
ON				BAR
		CONT		CAM
		ON	SHUTTER		ATW
OFF
		OFF
		TALLY
	2	3	4	5	1
		CONTROL
1	2	3	4	5
LEVEL	IRIS		MEMORY		6
			AUTO
			MANU

Multi Hybrid Control Panel AW-RP555

AWC	SCENE FILE
		USER
NG		1
OK				MENU
		2
ABC			MENU ITEM		YES	NO
		3
	PRESET			DEF	WIP	H/F
2	3	4	5
				(AF)	ND	OP
				EXT
7	8	9	10

LAMP

3.	Operate the ZOOM lever and PAN/TILT lever, and on the
	monitor check the pictures which are to be shot.
4.	Select the white balance from among the A, B and ATW
	buttons, and adjust the lens iris using the IRIS LEVEL
	control.
5.	Set the unit to a state in which the MEMORY button is
	held down.
	When the MEMORY button is pressed, those buttons
	among the PRESET buttons 1 through 10 in which data
	can be entered start flashing in sequence.
6.	While the MEMORY button is held down, press the
	button in which the preset memory data is to be entered.
7.	If necessary, enter other shooting positions and settings
	into other buttons among PRESET buttons 1 through 10
	as preset memory data.
8.	Select the next pan/tilt head system using the CONTROL
	button, and continue setting the preset memory data for
	each system concerned.

SPEED		ZOOM	FOCUS	PAN/TILT
LOW	TELE		FAR	UP
HIGH
			LEFT	RIGHT
	WIDE		NEAR	DOWN

Deleting preset memory data

1.Select the pan/tilt head system using the CONTROL button.

2.Press the OP button while holding down the MEMORY button.

3The OP button lamp starts flashing, and the standby mode is established.

4.Press the OP button to establish the setting mode.

The lamps of the PRESET 1 to 10 buttons start flashing in sequence. If the joystick is operated at this point, the deletion operation will be forcibly terminated.

5.Press the PRESET buttons whose memory data is to be deleted.

6.If necessary, delete other preset memory data as well.

24