Panasonic SC-BTT370 Preparing cables and making connection, Preventing the speakers from falling

[BTT370] [BTT273]

Thread the speaker cable through the base.

≥Use cables with a white connector and red connector.

Leave about

110 mm (4 11/32q)

Insert the wire fully. r: White

s: Blue line

Push!

Press into the groove.

Back of the base

	Pull the cable
	straight along the
	line and slide into the
Tighten securely.	groove.

Getting started

Preparing cables and making connection

1 Use of the speaker cable stickers is convenient when making cable connections.

e.g. Front speaker (L)

FRONT

Lch





ASpeaker cable sticker (supplied)

B Connector

Speaker cable sticker		Color
1	FRONT (L)	WHITE
2	FRONT (R)	RED
3	SURROUND (L)	BLUE
4	SURROUND (R)	GRAY
5	CENTER	GREEN
6	SUBWOOFER	PURPLE

2 Connecting the speaker cables. Insert the wire fully, taking care not to insert beyond the wire insulation.

≥[BTT770] Be sure to use the speaker cables that have a large connector and short cable when you use the wireless system.

e.g. Surround speaker

r: White

s: Blue line

Push!

Be sure to match the number on each sticker with the connector color.

≥Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers.

≥Don’t use a front speaker as a surround speaker or vice versa. Verify the type of speaker with the label on the rear of the speaker before connecting the appropriate cable.

≥To avoid injury by falling or dropping the speaker, place the speaker cables with care not to stumble or hook.

≥Do not hold the speaker in one hand to avoid injury by dropping the speaker when carrying.

[BTT770] [BTT370] [BTT273]

∫Preventing the speakers from falling

≥Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that may not have strong enough support. Improper attachment may result in damage to the wall or speakers.

≥Use a string of less than ‰ 2.0 mm (3/32q), which is capable of supporting over 10 kg (22 lbs).

e.g., [BTT770]

		A String (not supplied)
		Thread from the wall to the speaker and tie tightly.
		B Rear of the speaker
		C Screw eye (not supplied)
		D Wall

		E Approx.150 mm (5 29/32q)
		
		

VQT3D27

11