Panasonic CQ-DX200W Setup Menu display continued, User, TV Type, TV Display, On-Screen Messages

<Setup Menu> display (continued)

5. TV Type

TV standard format (PAL/NTSC) setting

(Default: NTSC (CQ-DX200W3)/PAL (CQ-DX200W5))

Note: Setting should be made to match the format of the connected monitor. Select NTSC if connections are made possible for both NTSC and PAL. If you select PAL, a picture may be partly omitted.

1.NTSC The unit transmits the NTSC formatted signal in either case, playing an NTSC formatted video or a PAL formatted video.

2.PAL The unit transmits the PAL formatted signal in either case, playing an NTSC formatted video or a PAL formatted video.

3.Multi The unit transmits the same video signal as the output of playing video software. Note: If the connected monitor cannot automatically select between NTSC and PAL according to the video signal of the disc to be reproduced, images on the screen may be distorted. Select NTSC or PAL at the monitor side depending on the disc to be reproduced.

4.Return The display returns to “Setup Menu”.

Note: Holding down the [OSD] button on the remote control for 2 sec. or more before disc play allows users to toggle between NTSC and PAL.

6. TV Display

Display aspect setting (Default: WIDE)

1.WIDE (16:9) Plays in the Wide mode when a wide-screen monitor is connected.

2.Pan & Scan (4:3) Plays in the Pan & Scan mode when a conventional monitor is connected.

3.Letterbox (4:3) Plays in the Letterbox mode when a conventional monitor is connected.

4. Return	The display returns to “Setup
	Menu”.

Note: If “Pan & Scan” or “Letterbox” is already set in the software, this setting shall be ignored.

7. On-Screen Messages

This is to select On-screen Display messages which will	English
be displayed when On-screen Display is turned off by
pressing [OSD]. (a Page 30)
(Default: ON)

1.ON When the power is turned on, On-Screen Display message such as “Play” and “Pause” will be displayed on the screen for 5 seconds.

2.OFF When the power is turned on, On-Screen Display messages such as “Play” and “Pause” will not be displayed on the screen.

3.Return The display returns to “Setup Menu”.

8.D.Range Compression

By compressing the range of the playback level (the dynamic range), it is possible to maintain the impact of audio even at low volumes.

This function only works with Dolby Digital encoded material.

(Default: OFF)

1.Minimum Most compressed mode: TV

broadcasts,etc

2.Standard Mode recommended by software creators for listening at low volumes.

3. OFF Not compressed dynamic range

4.Return The display returns to “Setup Menu”.

Note: When it is difficult to hear comparatively small sound (such as movie dialogue), selection of “Minimum” will make those sounds easier to hear.

	Settings
9. DivX Registration
(a Page 28)
To return to the “Setup Menu” display, press
[RETURN].	User

[MENU]

Numeric buttons

[1] – [9] [0]

(Finish the setting.)

CQ-DX200W37