Panasonic CS-MKE9NB4U Operation With The Remote Controller, Automatic Operation, Manual Operation

OPERATION WITH THE REMOTE CONTROLLER

1. Automatic Operation

The air conditioner calculates the difference between the thermostat setting and room temperature, and automatically determines the mode to operate under cooling or heating. Then, the air conditioner continuously operates under the mode selected at initial operation.

STEP 2

STEP 1

NOTE Check that the circuit breaker on the power panel is turned on.

Once mode is selected and the unit is preset by following the steps below, you can have the air conditioner automatically bring the room to the desired temperature simply by pressing the ON/OFF operation button.

STEP 1 Press the MODE selector button to .

STEP 2 Press the ON/OFF operation button.

To stop the air conditioner, press the ON/OFF operation button again.

NOTE • To change the temperature setting; press the temperature setting buttons and change the setting to the desired temperature.

2. Manual Operation

STEP 2

STEP 3

STEP 4 STEP 1 STEP 5

NOTE	Check that the circuit breaker on the power panel is
	turned on.
	If the automatic operation settings of the unit do not
	meet your needs, press the setting buttons as
	described below and change the settings as desired.
	STEP 1	Press the MODE selector button
		and select the desired mode.
		For heating operation			ο
		For dehumidifying operation			ο
		For cooling operation			ο
	STEP 2	To start the air conditioner, press the ON/
		OFF operation button.
	STEP 3	Press the TEMP. setting buttons to change
		the temperature setting to the desired
		temperature.
		Adjustable temperature range:
		30 °C max.	or	86 °F max.
		16 °C min.		60 °F min.
	STEP 4	Set the FAN SPEED selector button to the
		setting you want.
	STEP 5	Press the FLAP button and set the airflow
		direction as desired.
		(Refer to “ADJUSTING THE AIRFLOW
		DIRECTION” on page 13.)
	To stop the air conditioner, press the ON/OFF
	operation button again.
	• When multiple indoor units are used and units in other
NOTE
	rooms are already operating, they will be set to the
	same mode of operation as the operating indoor units.

•Choose the best position in the room for the remote controller, which also acts as the sensor for room comfort and transmits the operating instructions. Once you’ve found this best position, always keep the remote controller there.

•This appliance has a built-in 5-minute time delay circuit to ensure reliable operation. When the operation button is pressed, the compressor will start running within three minutes. In the event of power failure, the unit will stop.

9