Panasonic CZ-18BT1U, CS-MKE9NB4U, CU-4KE31NBU Using the Remote Controller, Single/Multiple switch

USING THE REMOTE CONTROLLER

HOW TO INSTALL BATTERIES

ACL button

1.Slide the cover in the direction indicated by the arrow and remove it.

2.Install two AAA alkaline batteries. Make sure the batteries point in the direction marked in the battery compartment.

3.Use a thin object such as the tip of a pen to press the ACL button.

	•	The batteries last about six months,
CAUTION
		depending on how much you use the
		remote controller. Replace the
		batteries when the remote controller’s
		display fails to light, or when the
		remote controller cannot be used to
		change the air conditioner’s settings.
	•	Use two fresh leak-proof type-AAA
		alkaline batteries.
	•	In replacing batteries, follow the
		instructions as mentioned in the
		subsection “HOW TO INSTALL
		BATTERIES”.
	•	If you do not use the remote controller
		more than 1 month, take out the
		batteries.
	•	Dispose of the used batteries at the
		designated location in compliance
		with the applicable local ordinances.

Information for Users on Collection and Disposal of Old Equipment and used Batteries

[Information on Disposal in other Countries outside the European Union]

These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal.

Note for the battery symbol (bottom two symbol examples):

This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved.

Pb

S/M (Single/Multiple switch)

•Initially, the S/M switch is set to S (Single).

•Set this switch to M (Multiple) for multiple operation.

•Always press ACL button by a thin object such as the tip of a pen after setting the S/M switch.

NOTE

When multiple indoor units are used and units in other rooms are already operating, they will be operating with the same mode as the operating indoor units.

HOW TO USE THE REMOTE CONTROLLER

When using the remote controller, always point the unit’s transmitter head directly at the air conditioner’s receiver.

Air Conditioner (Indoor unit)

Receiver

Remote Controller (Transmitter

head)

REMOTE CONTROLLER INSTALLATION POSITION

The remote controller may be operated either from a non-fixed position or from a wall-mounted position. To ensure that the air conditioner operates correctly, do not install the remote controller in the following places:

•In direct sunlight

•Behind a curtain or other places where it is covered

•More than 26 ft.(8 m) away from the air conditioner

•In the path of the air conditioner’s airstream

•Where it may become extremely hot or cold

•Where it may be subject to electrical or magnetic noise

•Where there is an obstacle between the remote controller and air conditioner (since a check signal is sent from the remote controller every 5 minutes)

MOUNTING THE REMOTE CONTROLLER

Before mounting the remote controller, press the ON/OFF operation button at the mounting location to make sure that the air conditioner operates from that location. The indoor unit should make a beeping sound to indicate that it has received the signal.

Remote Control Holder	Rear Side
Press
Set in	Hole
place

Mounting Screws	• To prevent loss of the remote
5/32 x 5/8"	controller, you can connect the
(4 x 16 mm)	remote controller to the holder by
(included)	passing a string through the remote
	controller and attachment hole.

To take out the remote controller, pull it forward.

WHEN HOLDING THE REMOTE CONTROLLER

•When using the remote controller and during air conditioner operation, the transmitter on the remote controller should be pointed towards the receiver on the indoor unit.

•Make sure that there are no objects between the remote controller and receiver which could block the signal.

8