WARNING Loose wiring may cause the terminal to overheat or result
in unit malfunction. A fire hazard may also exist. There- fore, be sure all wiring is tightly connected.
When connecting each power wire to the corresponding terminal, follow the instructions “How to connect wiring to the terminal” and fasten the wire securely tight with the fixing screw of the terminal plate.
How to connect wiring to the terminal
a) For Indoor Unit
9/32"
STRIP (7 mm) (ACTUAL
SIZESIZE)
(1)Cut the wire end with a cutting pliers, then strip the insulation to expose the wire about 9/32" (7 mm). See the label (Fig. 28) near the terminal plate.
(2)Using a screwdriver, loosen the terminal screw on the terminal plate.
(3)Insert the wire and tighten the terminal screw com- pletely using a screwdriver.
b) For Outdoor Unit
For solid core wiring (or F-cable)
(1)Cut the wire end with a cutting pliers, then strip the insulation to expose the solid wire about 15/16" (25 mm). (Fig. 29)
(2)Using a screwdriver, remove the terminal screw(s) on the terminal plate.
(3)Using the pliers, bend the solid wire to form a loop suitable for the terminal screw.
(4)Shape the loop wire properly, place it on the termi- nal plate and fix it securely with the removed termi- nal screw using a screwdriver.
For stranded wiring
(1) | Cut the wire end with a cutting pliers, then strip the |
| insulation to expose the stranded wiring about 3/8" |
| (10 mm) and tightly twist the wire ends. (Figs. 30 |
| and 31) |
(2) | Using a screwdriver, remove the terminal screw(s) |
Fig. 28
Strip 15/16" (25mm) | Solid wire | |
Insulation | ||
| ||
| Fig. 29 | |
Strip 3/8" (10 mm) | Stranded wire | |
|
Fig. 30
Twist wire ends
Fig. 31
/RRS
Ring connector
| on the terminal plate. |
(3) | Using a ring connector fastener or pliers, securely |
| clamp each stripped wire end with a ring connector. |
| (Fig. 30) |
(4) | Place the ring connector wire, and replace and |
| tighten the removed terminal screw using a screw- |
| driver. (Fig. 32) |
Special | Screw |
|
washer |
| |
| Ring connector | Screw and |
| special washer | |
Wire | Terminal plate | Ring |
| ||
|
| connector |
| Wire |
|
Fig. 32
13
