Panasonic CS-KS18NKU, CU-KS18NKU service manual Remote Controller Continued

REMOTE CONTROLLER (CONTINUED)

Temperature setting buttons		Press the		button to increase the set temperature.
(TEMP.)		Press the		button to reduce the set temperature.
		The temperature setting changes by 1 °C or 2 °F each time one of the TEMP.
		buttons is pressed.
MODE selector button		Use this button to select DRY, COOL or FAN mode.
	(DRY)		: The air conditioner reduces the humidity in the room.
(COOL)			: The air conditioner makes the room cooler.
	(FAN)		: The air conditioner works only as a circulation fan.
FAN SPEED selector button			: The air conditioner automatically decides the fan speeds.
			: High fan speed
			: Medium fan speed
			: Low fan speed
NIGHT SETBACK button		For details, see “4. Night Setback Mode”. When you press this button in the DRY
		or COOL mode, the mark appears in the display, and the remote controller will
		automatically adjust the set temperature to save energy.
FLAP button		Press this button either to select the setting of the airflow direction to the auto.
		flap in each mode or one of the six possible positions manually or to select the
		sweep function which moves the flap up and down automatically.
			: Auto flap setting: If selected in a cooling or dry operation, the flap is set at
			position (7) in the following chart.
			: The airflow direction can be set manually. (six positions)
			: The flap moves up and down automatically.
		When you press the FLAP button, the air flow direction will be changed one by
	NOTE
		one as follows.
					SWEEP
HIGH POWER button			: If this button is pressed during DRY, COOL or FAN operation, the unit
			operates at maximum output for 30 minutes, regardless of the desired
			temperature.
			The fan speed is 1 step above “High”.
ON TIME/OFF TIME setting		No display: The timer does not operate.
buttons			: The air conditioner starts at the set time.
			: The air conditioner stops at the set time.
				: The air conditioner stops and starts, or starts and stops, at the
				set times every day. For details, see “SETTING THE TIMER”.
SENSOR button		When you press this button (use a small-tipped object such as a ballpoint pen),
		the	mark will appear at the display. And the room temperature is detected by
		the sensor which is built into the indoor unit and the air conditioner is controlled
		accordingly.
		If the remote controller is located near a heat source, such as a space heater or in direct
	NOTE
		sunlight, press the SENSOR button to switch to the sensor on the indoor unit.

NOTE

The indoor fan runs continuously when the system is in normal operation. It does not turn off when the desired room temperature is reached. If Night Set Back mode is selected, the fan will turn off intermittently during cooling operation in order to control air flow.

9