Panasonic DMC-FZ2PP ª Battery indicator, ª Charging time and available recording time

Preparation

ªBattery indicator

The remaining battery power is displayed on the LCD monitor/Viewfinder. (This is not displayed when using AC adaptor)

: The battery power is sufficient

: The remaining power is a little low

: The remaining power is low

: Recharge or replace the battery

ªCharging time and available recording time

Measured under the following conditions:

•Temperature: 77°F (25°C)/Humidity: 60%

•Shooting once every 30 seconds, flash every other shot.

•Using the supplied SD Memory Card (Recording size: 1600k1200/Quality: Fine/ When deleting all pictures after full use)

	Charging time	Continuous recording/playback time
		(recordable number)
		Recording with LCD monitor
		Approx. 100 min.
		(equal to 200 still pictures)
Supplied battery	Approx. 90 min.	Recording with Viewfinder
		Approx. 120 min.
		(equal to 240 still pictures)
		Playback with LCD monitor
		Approx. 120 min.

The times shown in the table are approximate times. The times may vary depending on the condition.

ªCharging environment and charging error

•Charge the battery in a place with a temperature of 50oF – 95oF (10°C – 35°C). (The battery should also be the same temperature.)

•When charging starts, the [CHARGE] indicator lights. If, after charging starts, the [CHARGE] indicator blinks at about 1 second cycles, this indicates a charging error.

In this case, remove the AC adaptor from the electrical outlet, remove the battery and check if both room and battery temperature is too low or high and then charge it again. If the problem persists, consult the dealer or your nearest servicenter.

13