Panasonic DMC-FZ2PP Setting the Date/Time Clock Set, 1,6 2,3,4,5, Press the MENU button 2 times

Preparation

Setting the Date/Time (Clock Set)

7

1,6 2,3,4,5

3

REC	SETUP 2/2
NO.RESET
RESET
CLOCK SET
LANGUAGE	ENG

SELECT SET EXIT MENU

4,5

CLOCK SET

10:00 NOV. 1. 2003

M/D/Y

SELECT SET EXIT MENU

If the message [PLEASE SET THE CLOCK] appears, set the date and time.

You can go to the setup menu by pressing the [MENU] button while the message is displayed.

You can set the year from 2003 to 2099. The 24-hour system is used.

1Press the [MENU] button.

2Press 1 to make the setup menu appear.

•In simple mode, skip this step.

3Press 3/4 to select [CLOCK SET], and then press 1.

4Press 3/4/2/1 to set date and time, and then press 1.

5Press 3/4 to select [M/D/Y], [D/M/Y] or [Y/M/D].

6Press the [MENU] button 2 times.

•The menu will disappear.

7Check if the date/time setting is displayed correctly, after turning the camera [OFF] and [ON].

•It is possible to print the recording date.

When using the [SD Viewer for DSC] in the supplied CD-ROM, you can print with the recording date by setting its position on the picture. For further information (software installation), read the supplied operating instructions for PC connection.

•When you want digital printings with the recording date, be sure to order the printing of the date. For further information, ask a photo studio, a store, etc. Depending on the store, it may not be printed.

•After a fully charged battery is installed in the camera for at least 1 hour, the time and date will be held for approximately 24 hours if the battery is removed. If the battery was not fully charged the time may not be retained properly. If the time/ date setting is lost please reset it.

28