153
Recording
Taking Pictures using Burst Mode
Applicable modes:
Pictures are taken continuously while the shutter button is pressed.
Pictures taken with a burst speed of [SH] will be recorded as a single burst group (P79).
1Set the drive mode dial to [ ].
2Focus on the subject and take a picture.
AWhen Burst Mode is set to high speed [H].
•Hold down the shutter button fully to activate the Burst Mode.
∫Changing the burst speed
1Select [Burst Rate] in the [Rec] menu. (P37)
2Press 3/4 to select the burst speed and then press [MENU/SET].
[SH]
(Super high
speed)
[H]
(High speed)
[M]
(Middle
speed)
[L]
(Low speed)
Burst speed
(pictures/second) 20642
Live View during Burst
Mode None None Available Available
¢1With RAW files —18¢2, 3
Without RAW files Max. 80 Depends on the capacity of the card¢3
¢1 Number of recordable pictures
¢2 Depending on the recording conditions, the number of frames in a burst may be
reduced. (For example, when [i.Resolution] of the recording menu is set to
[EXTENDED], the number of frames in a burst may be reduced)
¢3 Pictures can be taken until the capacity of the card becomes full. However the burst
speed will become slower halfway. The exact timing of this depends on the aspect
ratio, the picture size, the setting for the quality and the type of card used.
•The Burst Mode speed may become slower depending on the following settings.
–[Picture Size] (P160)/[Quality] (P161)/[Sensitivity] (P134)/[Focus Mode] (P142)/[Focus/
Release Priority] (P55)
•Refer to P161 for information about RAW files.
AFSAFS
H
A