Panasonic DMC-LZ1PP, DMC-LZ2PP Folder Composition, Dcim, Misc, PictBridge PTP setting

Connecting to a PC or Printer

∫Folder Composition

The folder structure of the built-in memory, the card or MultiMediaCard is displayed as the illustration below.

≥Built-in memory	DCIM
≥SD Memory Card				100_PANA
≥MultiMediaCard
	1
		100_PANA
			P1000001.JPG
	2				3

P1000002.JPG

P1000999.JPG 101_PANA

999_PANA

MISC

1Folder number

2 File number

3 JPG: pictures MOV: motion images

Files will be saved in each folder as follows.

DCIM	Folders from [100_PANA] to
	[999_PANA]
100_PANA	Pictures/motion images
MISC	Files on which the DPOF
	print settings are recorded

•When recording, up to 999 picture data can be included in 1 folder. If the number of picture data exceeds 999, another folder will be created.

•When you reset the file number or the folder number, select [NO.RESET] in the [SETUP] menu. (P24)

•If the remaining battery power is exhausted during communication, the recorded data may be damaged. When you connect the camera to the PC, use batteries with sufficient battery power (P14) or the AC adaptor (DMW-AC1; optional).

•If the remaining battery power becomes low during communication, the status indicator blinks and the alarm beeps. In this case, stop the communication at once.

•While [ACCESS] is being displayed, do not disconnect the USB connection cable.

•When the OS of your PC is Windows 2000 and you connect the camera to the PC with the USB connection cable, do not replace the card with the camera connected to the PC. The information in the card may be damaged.

•Do not use any other USB connection cables except the supplied one.

•For more information, refer to the separate operating instructions about PC connection.

•Also refer to the operating instructions of the PC.

•If the card is not inserted when the camera is connected to a PC, you can edit or access the picture data in the built-in memory. If the card is inserted, you can edit or access the picture data in it.

•You cannot switch the recording medium between the built-in memory and the card while the camera is connected to the PC. When you want to switch the recording medium, disconnect the USB connection cable, insert (or remove) the card and then connect the USB connection cable to the PC again.

∫PictBridge (PTP) setting

Even if you set the [USB MODE] to [PictBridge (PTP)], you can connect to the PC only when the OS is Windows XP Home Edition, Windows XP Professional or Mac OS X.

•You can only load pictures from the camera and cannot write them on the card or delete them.

•When there are 1000 or more pictures on a card, the pictures may not be imported.

87

VQT0P65