Reference
37
VQT3B58
Messages
The following messages or service numbers appear on the
television or unit’s display when something unusual is
detected during startup and use.

Cannot play.

¾
You inserted an incompatib le disc (Discs record ed in
PAL video, etc.).

Cannot display on this un i t.

¾
You tried to play a non-compatible image.
¾
Confirm “SD” on the unit’s display is not displayed and
re-insert the card.

No disc is inse rted.

¾
The disc may be upside down.
$ This operation is not available.
¾
Some operations are unsupported by the unit. For
example;
–BD-Video: During playback, reverse slow-motion or
reverse frame-by-frame is not possible.

IP address is not set.

¾
The “IP Address” in “IP Address/DNS Settings” is “---.
---. ---. ---”. Set the “IP Address”, “Subnet Mask”, and
“Default Gateway”. (Select the au tomatic address
acquisition if necessary.)

The current settings only offer minimal

wireless access point security and low

performance. It is recommended to change it

for better security.

¾
Authentication type for the Wireless LAN is set to “Open
system”, or the encryption type is set to “No encryptio n”.
It is recommended to encrypt fo r safety reasons. For
details, refer to the instructi ons of the Wireless router
being used. Encryption is required when playing back
video, etc., from DLNA compatible devices.

F99

¾
The unit fails to operate properly. Press [POWER Í/I]
on the main unit for 3 seconds to switch the unit to
standby, then switch back on.

HDMI ONLY

¾
Some BD-Video discs can only be output with HDMI.

NET

¾
While connecting to a network.

No PLAY

¾
There is a viewing re striction on a BD-Video o r
DVD-Video. (29)

No READ

¾
The media is dirty or b adly scratched. The un it cannot
play.

PLEASE WAIT

¾
The unit is carrying out an intern al process. This is not a
malfunction. You cann ot opera te the uni t whil e “PLE ASE
WAIT” is displayed.

REMOVE

¾
The USB device is drawing too mu ch power. Remove
the USB device.

SET

(“” stands for a number.)
¾
The remote control and main uni t ar e us in g diff e ren t
codes. Change the code on the remote control.
Press and hold [OK] and the
indicated number button at th e
same time for more than
5se conds.

U59

¾
The unit is hot.
The unit switches to standby for safe ty re ason s. Wa it for
about 30 minutes until the mess age disappears.
Select a position with good ventilati on when in sta lli ng
the unit. Do not block the ventilation hole on the side of
the unit.

H or F

(“” stands for a number.)
¾
There is something unusual.
¾
Check the unit using the troubleshooting guide. If the
service number does not disappear, do the following.
1Disconnect the plug from the AC ou tlet, wait a few
seconds, then reconnect it.
2Press [POWER Í/I] to turn the power on .
If the service number does not disappear despite doing the
above, request servic e from the dealer. Inform th e dealer of
the service number when requesting service.

START

¾
The system is being res tarted during the firmw are
update. Please do not turn off the u nit.

UPD/

(“” stands for a number.)
¾
The firmware is being updated.
Please do not turn off the unit.

FINISH

¾
The firmware update is complete.

On the television

On the unit’s display

DMP-BDT110_210_VQT3B58_eng.book 37 ページ ２０１１年５月１７日　火曜日　午後４時４３分