As a rule, clean weekly, Light Copies, Glass

Check

Light Copies

Does the exposure indicator say “lighter”?

Does the add toner indicator and message appear on the display? (?)

Marked Copies

Troubleshooting

Action

Press the Scroll key until the indicator LED is set to Darker. (See P.12)

Replace the Toner Cartridge. (See P.46)

Is the copier platen glass or platen cover dirty?

Is the original an OHP film or a dark original?

Clean the glass or platen cover. (See below)

Cover the original with a sheet of white paper before copying or lighten the exposure setting.

■If the measures outlined above do not solve the problem, call your Service provider.

Copier Care

■As a rule, clean weekly.

Platen Cover

Platen

(glass)

Platen/Platen Cover

#Wipe marks off with a cloth and a neutral detergent.

$Wipe again with a dry cloth.

57	Others

Page 57

Image 57

Panasonic DP-200 manual As a rule, clean weekly, Light Copies, Marked Copies, Platen Cover, Glass

Contents

English DP-2000 Common Features and Usage Operation Chart Energy Star Table of Contents Problem Solving OptionsOthers Precautions For Your SafetyLaser Safety Handling Toner and Paper Ventilation Precautions FCC Warning For U.S.A Installation Control Panel Reset Key Contents Refer to Function KeyClear Keys Stop Key Edge Key Contents Refer to Book KeyMargin Key Cursor Keys Full Size Copying Basic Copy Reduction or Enlargement Copying Copying with Preset RatiosSelect the Copy Size Zoom Copying ZoomPress Cursor F or G keys to select Zoom Ratio $Adjust the side guides Using the Sheet BypassCopying on Special Paper, etc # Place approximately 50 sheets of paper into the tray Sided/1-Sided Copy Sided/Original H Copy Duplex CopyKey Operation Book \ \ 2/2 \ 1/2 \ 2 Copy ProcedurePress 2-Sided Sided Copy key Place the Original on the Platen Book \ 2 CopyBook \ 2 Copy Platen Press 1 Copy1 key 1 Copy Copy Place Press OriginalsKey Book/Edge/Margin MarginPress Book, Edge or Margin key Press the Copied key or the Blank key OHP InterleavingOHP Interleaving Blank Paper To recall a job stored in memory To store a job in memory Energy Saver Mode Energy Saver/Interrupt ModeSleep Mode Interrupt Mode Skyshot Mode Setting the Digital Skyshot ModeProceed as Follows Copying with the Manual Skyshot Mode Setting the Manual Skyshot Mode Press the Function KeySet Manual Skyshot mode first Platen Upper- left corner Sort Combined Function TableCopy SIDED/ORIG Function Using Function Modes to Change the Initial Copy ModesOptions Input Identification Code General Functions Modes Function Initial Setting Copier Settings General Functions for Key Operator Copier Settings for Key Operator Changing the Auto Exposure Setting Function Setting Changing the Paper Size Function Setting for Key Operator Paper Guide a Stopper Guide b Departmental Counter Counter 6 digits Components Accessories Automatic Document Feeder FeaturesADF DA-AS200/i-ADF DA-AR250 Components Place OperationOriginal Inappropriate originals DA-FS200 Finisher Finisher/Exit Guide UnitPlaten Face-Up Press Sort/Finish key Pull out the tape Replacing the staple cartridge Reinstall the staple cartridge #Open the staple cover Problem Solving Adding Paper JSheet Paper Tray Open the front cover Replacing the Toner Cartridge and Waste Toner Box ?Slowly pull the waste toner box Straight out Install a new waste toner box Install the new toner cartridge intoShake the new toner cartridge Well Misfeed Indicator Removing a Misfeed PaperPaper Misfeed Locations Finisher Paper Transport Area Removing a Misfed Paper Open the right cover Paper Entry Area Close the right cover Automatic Duplex Unit ADU System Console ADF/i-ADF #Lift up the ADF Input Tray Before Calling Service TroubleshootingCheck Action Light Copies As a rule, clean weeklyMarked Copies Platen Cover Replacing the Battery Battery Replacement Required MessageBattery Replacement Procedure DP-2000 Copier Specifications ADF DA-AS200, i-ADF DA-AR250 Bin Finisher DA-FS2002nd/3rd/4th Paper Feed Module DA-DS210/DA-DS200 Part Name Remarks Options and Supplies For Printer For Fax Warranty