115 | Panasonic HDC-SD1PP manual

Others

Problem

Check points

This unit cannot be	≥The unit cannot be operated if the LCD monitor is not opened.
operated though	≥Press the RESET button. (l 118) If normal conditions are not
powered up.	restored yet, remove the battery or AC adaptor, wait about 1 minute
This unit does not	and then reconnect the battery or AC adaptor. Then about 1 minute
This unit does not	later, turn on the power again. (Conducting the above operation
operate normally.	while the card is being accessed may damage the data on the
	SD card.)
The remote control does	≥Has the button-type battery of the remote control run out?
not function.	# Replace it with a new button-type battery. (l 25)
The screen has changed	≥Has the demonstration started?
suddenly.	# If you set [DEMO MODE] to [ON] without inserting an SD card in
	recording mode, the demonstration automatically starts.
	Normally this should be set to [OFF]. Press the MENU button,
	then select [SETUP] # [DEMO MODE] # [OFF] and press the
	cursor button.
A function indication	≥If you set [SETUP] > [DISPLAY] > [OFF], indications other than
such as the remaining	warnings and date indications disappear.
time indication or the
elapsed time indication is
not shown.
Recording does not start	≥Has the SD card’s write protect switch been set to LOCK?
although power is	# No recording is possible while the write protect switch is set to
supplied to this unit and	LOCK. (l 27)
the SD card is correctly	≥Is the memory of the SD card full?
inserted.	# If there is no more available memory, free up some memory by
	deleting unnecessary scenes or use a new SD card. (l 34, 74,
	76)
	≥Is the unit set to recording mode?
	# No recording is possible if the mode dial is set to other than	.
	≥Is the card slot cover open?
	# If the card slot cover is open, this unit may not operate normally.
	Close the card slot cover.
The unit arbitrarily stops	≥Can the SD card be used for motion picture recording?
recording.	# Use an SD card that can be used for motion picture recording.
	(l 26)
	≥Is the AGS function activated?
	# Record in the normal horizontal position or set [AGS] to [OFF].
	(l 44)

115

VQT1A24

Image 115

Panasonic HDC-SD1PP operating instructions 115

Contents

Operating Instructions Things You Should Know Safety PrecautionsThank you for choosing Panasonic Declaration of Conformity FCC NoteComputer or peripheral devices Equipment AC adaptor Batteries Important Safety Instructions USE & Location Precautions Carefully observe copyright laws Indemnity concerning recording ContentCards that you can use with this Unit Motion picture playback Quick GuideBefore recording Manual recording functions Contents Editing Quick Guide Securely close the card slot cover Inserting/removing an SD cardRecording motion pictures Recording still pictures Jpeg Press the cursor button Move the cursor button to operate Motion picture playbackStill picture Jpeg playback Select the scene to be played back High definition images Features of the High Definition Video CameraWhat is the AVCHD? Very clear high definition pictures Watching high definition images When connecting to a TV that does not have a Hdmi terminalHigh definition TV B Hdmi cable optional Other linked operations Using the remote control for the TV for playbackTurning the power on and off Automatic input switching Internal microphones Listening in 5.1 channel surround soundAV amplifier with Hdmi terminal B Hdmi cable optional Important note Saving the data on the SD cardWhat you can do with HD Writer SD Media Storage USA only Accessories About the cooling fan Parts identification and handling VQT1A24 Component terminal Component l Microphone terminal MIC ≥Use the supplied AV cable only Open the battery cover Battery cable coverClose the battery cover Flip the belt Put your hand through the grip belt Using grip belt ≥It can open up to 90o Using the LCD monitorUsing the remote control Adjust the angle of the LCD monitor as desired Remote control usable range Install a button-type batteryConcerning the button-type battery Cards that you can use with this unit SD Speed Class Rating Class Handling precautions Charging lamp Charging the batterySetup Connect the AC cable to the AC Adaptor and the AC outlet Inserting the battery Open the battery cover Inserting/removing the battery Recordable time Charging time and recordable timeAbout batteries that you can use for this unit Charging time About the remaining battery Capacity indication Connecting to the AC outlet≥The display changes as the battery capacity reduces Playback mode l 68 Selecting a mode Turning the unit on/offHow to turn off the power Set the mode dial to OFF Recording mode l 45 Quick start Turning the power on and off with the LCD monitorTo turn on the power To turn off the power Open the LCD monitor To cancel Quick start≥Check that the status indicator has gone off Inserting/removing an SD card Basic operations How to use the cursor buttonCard access lamp Concerning the SD card Operations during recording ¬ Rotate the mode dial to selectMove the cursor button up, down, left or right to operate Set the AUTO/MANUAL/FOCUS switch to Focus Set the AUTO/MANUAL/FOCUS switch to ManualManual focus Mode Focus Playback mode In still picture playback Playback mode In motion picture playback While stopped, press the Menu button Using the menu screenHelp mode To exit the help mode Press the Menu button to exit the menu screen Operating with remote controlPress the Menu button Select a menu item Changing the date and time display style Setting date and timeTo recharge the built-in lithium battery Press the cursor button to enter Selection Adjusting LCD monitor Switching the languageColor level of the LCD monitor Basic camera positioning Before recordingRecording Automatic white balance l Auto focus l About auto modeAuto Ground-Directional Standby AGS Turning the AGS function on/off Record motion pictures on an SD card Rotate the mode dial to selectRecording motion pictures To end the recording ≥Maximum number of recordable scenes with different dates Screen indications in the recording modeMinute, R0min flashes red Recording time elapsed Min ≥Recordable time using the battery l Control cannot be pressed halfway Recording still pictures JpegPress the Photo Shot button fully to take the picture To record still pictures clearly About the focus indication Concerning the focusing areaCard indication l Mega optical image stabilizer l You can add a shutter sound when recording still pictures Switching the shutter effect on/off 16 MB 32 MB 64 MB 128 MB Picture quality≥The number of recordable pictures depends Digital zoom function Various recording functionsZoom in/out function Move the zoom lever You can record yourself while viewing the LCD monitor About using the zoom microphone functionRecording yourself Rotate the LCD monitor towards the lens side Start recording. Fade Backlight compensation functionFade in/fade out function To return to normal recording Press the recording start/stop Button To cancel fadingTo cancel the MagicPix function MagicPix function Tele macro function Soft skin modeTo cancel the soft skin mode To cancel the tele macro function Built-in flash Self-timer recordingTo stop the timer midway through You can record still pictures on an SD card using the timer Flash is activated and the picture will be recorded When the flash is not used≥This function’s default setting is Flash Auto Red eye reduction function Image stabilizer function To cancel the image stabilizer functionGuide line function Microphone level To cancel the guide line functionTo cancel the wind noise reduction function Wind noise reduction function To return to automatic setting Color bar To cancel the zebra displayTo cancel the color bar Zebra display Manual recording functions Scene modeSet the AUTO/MANUAL/FOCUS switch to Manual To cancel the scene mode function When MF assist function is used Manual focus adjustmentMove the switch down and set it to Focus position To restore to the automatic adjustment White balance About the black balance Adjustment Manual shutter speed/aperture adjustmentAbout the white balance sensor Set the AUTO/MANUAL/FOCUS switch to To restore to automatic adjustmentManual shutter speed adjustment Manual iris/gain adjustment Move the cursor button to operate Motion picture playbackSelect the scene to be played back Press the cursor button About motion picture Compatibility Press the or 9 button on the remote control during playbackOperating with the remote Control Operation is possible with the remote control only Press the button To adjust the volumeMove the volume lever to change the volume level Frame-by-frame playback To return to playing back all the scenes To cancel the repeat playback functionPlaying back motion pictures by date Repeat playback Select the file to be played back To cancel the resume playback functionStill picture Jpeg playback Resuming the previous playback About still picture compatibility Deleting scenes Editing scenesDeleting scenes one at a time To continue deleting other scenes To complete the settingsEditing Only when Select is selected in step Protecting scenes Select the file to be deleted, then press the cursor button Editing still picturesDeleting still pictures Deleting files one at a time To continue deleting other files Protecting still pictures Number of prints set to be in Dpof is displayed Dpof settingWhat is DPOF? To cancel all Dpof settings Card management ¬ Rotate the mode dial to select orFormatting Formatting an SD card To watch images with a Aspect ratio on a regular TV With a TVPlayback on TV To display the on-screen Information on the TV Start playback on this unit Connecting with a Hdmi cable optionalWhat is HDMI? Connect this unit and a TV with the Hdmi cable optional Hdmi output resolution About the settings when Connecting with Hdmi Listening in 5.1 channel sound Component Video Audio About the setting when connecting the component terminals If the image or audio from this Unit is not output on the TV AV cable supplied Page To cancel EZ SyncTM Hdavi ControlTM Operate with the remote control for the TV AV cable supplied ≥Insert the plugs as far as they will go About the battery running downConnect this unit and a video device To stop dubbing Select a file to be printed, then press the cursor button Select the paper size setting on Paper SizeWith a printer PictBridge Connect this unit and a printer Frame print Select the layout setting on page LayoutWhen you stop printing halfway No frame print Data type Can do Software used Before using with a computerWhat you can do with a computer With a computer Contents on provided CD-ROM End User License Agreement Operating environment for HD Writer Ver1.0E for SD1 Operating environment USB port Microsoft Windows XP Home EditionMicrosoft Windows XP Professional MB or more 256 MB or more recommended Click HD Writer Ver1.0E for SD1 InstallationInstalling HD Writer Ver1.0E for SD1 Insert the CD-ROM into the computer Select start # Software application uninstallationComputer must be rebooted for the application to work Click Finish Insert the battery and connect the AC adaptor Connection and recognition proceduresConnection and recognition 100 Set the mode dial on the unit toAbout the computer display Computer 101 To disconnect USB cable safelyVerifying the unit is correctly recognized by the computer If the driver has not been Recognized properly On the computer Using HD Writer Ver1.0E for SD1Click the Copy to PC button 102 Writing back to an SD card Click the Start copying button103 104 If using Macintosh Menu list Menus and Indications Scene Protect l 77 Dpof SET l Playback menus Motion picture playback Play SetupLanguage l Playback menus Still picture playback Play Setup 106 Menus related to Advanced and Setup Recording indications Indications108 109 Playback indicationsPC connection indications Confirmatory indications 110 Messages 111 112 About recovery Functions that cannot be used simultaneously Unit operations Troubleshooting114 115 116 117 118 With a computer When connected to another device119 120 When carrying the unit, do not drop or bump itWhen you are not going to use the unit for an extended time About this unit About the AC adaptor About the battery121 122 About the SD cardAbout the miniSD Card LCD monitor What to do with the lens is fogged up Explanation of termsAbout condensation Causes of condensation Auto focus White balance124 125 Specifications 126 127 128 Optional accessories 129 Accessory Order Form For USA Customers 130 Request for Service Notice USA Only 131 Limited Warranty For USA Customers 132 Customer Services Directory Camcorder Product One 1 year, parts and labour Warranty For Canadian CustomersPanasonic Canada Inc 133 134 Index 112 135130 Cómo encender la unidad Carga de la bateríaInserción de la batería Extracción de la batería 137 Insertar/extraer una tarjeta SDGrabación de películas Grabación de fotografías Jpeg Seleccione la escena que desea reproducir Reproducción de películasReproducción de fotografías 138 139 Panasonic Puerto Rico, Inc