110
VQT1Y00
≥The disc that was copied to can be played back by connecting this unit and a DVD burner.
(l111)
≥Do not turn off this unit or the DVD burner or disconnect the MiniAB USB Connect ion Cable while
copying. Also, do not shake this unit or the DVD burner.
≥It is impossible to stop copying halfway.
≥The order in which the scenes were copied cannot be changed.
≥Data that has been recorded on another device may not be copied.
≥When 2 or more discs are necessary for copying, the last scene copied to a disc is automatically
divided to fit the space on the disc.
≥Copying may be completed using less discs than the number displayed if scenes were automatically
divided.
≥When the disc that was copied to is played back on another device, the picture may momentarily stop
at the points where the scenes switch.
≥Discs copied in [Standard (XP)]/[Standard (SP)] cannot be used in the Intelligent Scene Selection or
Highlight Playback.
About the approximate time it takes for copying to a disc
To copy motion pictures to the full capacity of a disc
Disc type Copy time
[High Definition] [Standard (XP)] [Standard (SP)]
DVD-RAM Approx.
50 min to 80 min
Approx.
90 min to 120 min Approx.
135 min to 180 min
DVD-RW*Approx.
35 min to 75 min
DVD-R*Approx.
15 min to 45 min
* Eve n if the data capacity to be copied is small, the time it takes for copying may be about the same
as the time shown in the table.
≥When copying motion pictures in standard picture quality to a disc, the recordable time of
[Standard (XP)] is approx. 60m inutes and that of [Standard (SP)] is approx. 120 minutes.
To copy 600 still pictures (approx. 600MB)
Disc type Copy time
DVD-RAM/DVD-RW/DVD-R Approx. 30 min to 40 min
≥Copy time of DVD-R DL is approximately 2 to 3 times that of DVD-R.
≥Depending on the following conditions, the time it takes for copying may be longer than the above
times.
jWhen the number of recorded scenes is large
jWhen the temperature of the DVD burner has become high
HDCSD20&SD25&HS20P-VQT1Y00_eng.book 110 ページ ２００８年１２月２２日　月曜日　午後８時１６分