Others
113
VQT1H62
When the SD card is accessed, you try to playback a scene or faulty control information is read, one of
the messages below may be displayed. (Depending on the error, this may take time.)
When connecting to AC adaptor or the remaining capacity of the battery is enough:
[FINISHED.]
When the remaining capacity of the battery is low:
[CANNOT REPAIR CONTROL INFORMATION DUE TO LOW BATTERY POWER.]
When connecting to AC adaptor or the remaining capacity of the battery is enough:
[THUMBNAIL DATA HAS BEEN REPAIRED SUCCESSFULLY.]
THIS BATTERY CANNOT
BE USED.
Use a battery that is compatible with this unit. (l28)
You are attempting to connect an AC adaptor not compatible with
this unit. Use the supplied AC adaptor. (l30)
If using a Panasonic battery compatible with this unit (l28), eject
the battery and then insert it again. If the message appears even
after repeating this several times, this unit needs repair. Detach the
power and consult the dealer who you purchased this unit from. Do
not attempt to repair it by yourself.
AGS MODE ON-REC
PAUSED The AGS function is activated. (l42)
PUSH THE RESET
SWITCH.
An irregularity in the unit has been detected. Press the RESET
button to restart the unit. (l118)
CANNOT SET. The [GUIDE LINES], [ZEBRA], [MF ASSIST], [MIC LEVEL] and
[RED EYE] menu settings cannot be set when the color bar is set.
CANNOT CHECK
CONNECTED DEVICE.
DISCONNECT THE USB
CABLE FROM THIS UNIT.
The DVD burner is not correctly connected.
Disconnect and then reconnect the Mini AB USB Connection Cable.
Connect a DVD burner that is compatible with this unit. (l83)
PLEASE CHECK
EXTERNAL DRIVE OR
DISC.
A disc is not inserted in the DVD burner. Or, this unit and the DVD
burner were connected and then a disc that cannot be used was
inserted. Connect this unit to the DVD burner and then insert a disc
that can be used for copying. (l83)
PLEASE CHECK THE
DISC.
Copying is not possible as you connected this unit to the DVD
burner and then inserted a disc that cannot be used or a used disc.
Use a new disc. (l83)
DISCONNECT USB
CABLE.
The unit cannot correctly establish the connection to the computer
or printer. Disconnect and then reconnect the USB cable.
DISCONNECT USB
CABLE.
You cannot turn off this unit while it is connected to a PC or a DVD
burner.
About recovery
CONTROL DATA ERROR HAS BEEN DETECTED.
THUMBNAIL DATA ERROR IS DETECTED.
VQT1H62_ENG_PP.book 113 ページ ２００７年７月１７日　火曜日　午後５時４４分