27
VQT1H62
Setup
Inserting/removing the battery
1While sliding the SD CARD/
BATTERYOPEN lever A, move
the SD card/battery cover and
open it.
2Insert the battery until it clicks
while paying attention to the
direction of the battery.
BPush the center of the battery until it locks.
3Close the SD card/battery cover.
Securely close it until it clicks.
1Open the SD card/battery cover.
2Remove the battery.
Move A in the direction of the arrow to unlock
it and then remove the battery.
3Close the SD card/battery cover.
Be sure to set the mode dial to OFF and check
that the status indicator is off before removing
the battery.
The SD card/battery cover opens up to 180o.
Inserting the battery
A
1
2
B
Removing the battery
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
A
VQT1H62_ENG_PP.book 27 ページ 2007年7月17日 火曜日 午後5時44分