26
VQT1H62
Setup
Setup

Charging the battery

When this unit is purchased, the battery is not
charged. Charge the battery before using this
unit.
≥Connect the battery to an AC adaptor to
recharge it.
≥Refer to page 28 concerning batteries that
can be used with this unit.
1Connect the AC cable to the AC

adaptor and the AC outlet.

≥Remove the DC cable beforehand.
2Put the battery on the battery

mount by aligning the mark, and

then securely plug it in.

≥The output plug of the AC cable is not
completely connected to the AC adaptor jack.
As shown in A, there is a gap.

ªCharging lamp

Lights up:
Charging
Goes off:
Charging completed
Flashing:
Make sure that the terminals of the battery or the
AC adaptor are not exposed to dirt, foreign
objects or dust, then reconnect them properly.
Disconnect the AC cable from the AC outlet
when you remove dirt, foreign objects or dust on
the terminals of the battery or the AC adaptor.
If the charging lamp is still flashing, something
may be wrong with the battery or AC adaptor.
Contact your dealer.
≥Battery charging time (l28)
≥We recommend using Panasonic batteries
(l10, 28, 132).
≥If you use other batteries, we cannot guarantee
the performance/quality of this product.
If the DC cable is connected to the AC
adaptor, then the battery will not charge.
Remove the DC cable from the AC adaptor.
A
VQT1H62_ENG_PP.book 26 ページ ２００７年７月１７日　火曜日　午後５時４４分