134
VQT1Y59
Problem Check points
This unit cannot be
operated though it is
turned on.
This unit does not operate
normally.
≥Turn on the power again. If normal conditions are not
restored yet, remove the battery or AC adaptor, wait about
1 minute and then reconnect the battery or AC adaptor.
Then about 1 minute later, turn on the power again.
(Conducting the above operation while the media is being
accessed may damage the data on the media.)
≥If normal operation is still not restored, detach the power
connected, and consult the dealer who you purchased this
unit from.
Recording does not start
although power is
supplied to this unit and
the SD card is correctly
inserted.
≥
A message is displayed and you cannot record when the
HDD does not operate normally due to the temperature of the
unit being too high or low, when the built-in memory does not
operate normally, or when the SD card cover cannot be
closed due to failure of the SD card cover. In this case, press
the recording start/stop button to display the media change
message, allowing you to change the recording media.
Item other than the
touched one is selected.
≥Calibrate the touch screen. (l36)
The remote control does
not function.
≥Remote control cannot be operated when the [REMOTE
CONTROL] is set to [OFF].
≥The button-type battery of the remote control may be run
out. Replace it with a new button-type battery. (l37)
The remaining time
indication or the elapsed
time indication is not shown.
≥If you set [SETUP] > [DISPLAY] > [OFF], indications other
than warnings and date etc. are not displayed. (l29)
The unit arbitrarily stops
recording.
≥Use an SD card that can be used for motion picture
recording. (l22) When the unit stops while a usable SD
card for recording motion pictures (l22) is used, the data
writing rate has deteriorated. We recommend formatting the
SD card being used. (l94)
≥If [AGS] is [ON], record in the normal horizontal position or
set [AGS] to [OFF]. (l64)
≥
If the unit is exposed to strong vibrations or shocks while
recording on HDD, recording may stop to protect the HDD. If
the unit is used in a place with loud sounds, the recording
may stop due to sound vibrations. Recording data on an SD
card is recommended in these places.
≥Many repeated recording and deletion of motion pictures
may reduce the usable time for recording on a media you
use. In that case, format the media.
HDCTM200&HS200GN-VQT1Y59_mst.book 134 ページ ２００９年１月１５日 木曜日 午後７時３２分