43
VQT1Y59
3Open the LCD monitor.
The status indicator A lights red and the unit is
put into recording pause.
≥Quick start standby mode is cancelled if
jabout 5 minutes elapsed
jmode is set to
junit is turned off
≥Time for quick start will be more than
0.6 seconds slower when digital cinema is
used.
≥Depending on the recording conditions, time
for quick start may be more than 0.6 seconds
slower in still picture recording mode.
≥It may take some time for automatic white
balance to adjust.
≥In the quick start mode, the zoom
magnification becomes 1k.
≥If [ECONOMY] (l29) is set to [5MINUTES]
and the unit automatically goes into quick start
standby mode, close the LCD monitor and then
open it again.
≥Quick start standby mode cannot be released
by the remote control. Turn the mode to OFF
when powering off.
(Only when recording to an SD card or
built-in memory)
The unit is put into recording pause approx.
1.9 seconds when the mode is set to or
from OFF.
≥Start time will not shorten if there is no SD card
inserted.
Start time will be shorten if the [Built-in
Memory] is selected in the [MEDIA SELECT],
even if there is no SD card inserted.
¬Change the mode to or .
1Select SD card as a media to
record from the menu. (l27)
2Select the menu. (l27)
≥This function’s default setting is [ON].
≥Depending on the recording conditions, start
time may be longer than 1.9 seconds in still
picture recording mode.
≥In the quick power on mode, the zoom
magnification becomes 1k.
HDC-HS200
HDC-TM200
Quick power on
[MEDIA SELECT] # [SD CARD]
[SETUP] # [QUICK POWER ON] # [ON]
HDCTM200&HS200GN-VQT1Y59_mst.book 43 ページ 2009年1月15日 木曜日 午後7時32分