Quick Guide
Charging the battery
Charging lamp [CHARGE]
Lights up:
Charging
Goes off:
Charging completed
Connect the AC cable to the AC adaptor and the AC outlet.
Insert the battery into the AC adaptor by aligning the arrows.
Inserting the battery
Install the battery by inserting it in the direction shown in the figure.
Insert the battery until it clicks and locks.
Inserting/removing an SD card
OPEN
1) Open the LCD monitor.
Check that the access lamp has gone off.
2)Open the SD card cover by sliding the OPEN lever .
3)Insert/remove the SD card.
Face the label side in the direction shown in the illustration and press it straight in as far as it will go.
Press the center of the SD card and then pull it straight out.
4)Securely close the SD card cover. Securely close it until it clicks.
How to turn on the power
Turn on the power by changing the mode to 
,
or 
while pressing the lock release button .
HDC-TM300
Rotate the mode dial while at the same time pressing in the lock release button if changing from OFF to another mode. Align with .
Status indicator
HDC-HS300
Access lamp [ACCESS]
When this unit is accessing the SD card or
12
Rotate the mode dial while at the same time pressing in the lock release button if changing from OFF to another mode. Align with .
Status indicator
To turn off the power, change the mode to OFF.
VQT1Z09
