DISCONNECT USB CABLE.
The unit cannot correctly establish the connection to the PC or printer. Disconnect and then reconnect the USB cable.
* 
only
About recovery
If faulty management information is found, one of the following messages may appear. Be sure to follow directions in the messages. (Repairing may take time depending on the error.)
CONTROL DATA ERROR HAS BEEN DETECTED. (SD CARD)
CONTROL DATA ERROR DETECTED IN THE
CONTROL DATA ERROR HAS BEEN DETECTED. (HDD)*2
THUMBNAIL DATA ERROR IS DETECTED.
*1 | only |
*2 | only |
The following message is displayed when abnormal management information is detected when the scenes are displayed in thumbnail. To perform the repair, touch the scene with in the thumbnail, and start the playback. Please be aware that if the repair fails, scenes with will be deleted.
SOME SCENES NEED REPAIRING. PLAY SCENES TO BE REPAIRED. (IRREPARABLE SCENES WILL BE DELETED.)
Use a sufficiently charged battery or the AC adaptor.
Depending on the condition of the data, it may not be possible to completely repair the data.
When data recorded on another device is recovered, it may not be possible to play back the data on this unit or the other device.
If recovery fails, turn the power of the unit off and on again after waiting a while. If recovery fails repeatedly, format a media on the unit. Please be aware that if a media is formatted, then all the data recorded on the media will be erased.
If the thumbnail information is recovered, displaying the thumbnails may become slower.
