3 Open the LCD monitor or extend the viewfinder.
HDC-TM300
HDC-HS300
The status indicator lights red and the unit is put into recording pause.
Quick Start Standby Mode is canceled if about 5 minutes have elapsed mode is set to 
unit is turned off
Time for Quick Start will be more than 0.6 seconds slower when the digital cinema is used.
Depending on the recording conditions, time for Quick Start may be more than 0.6 seconds slower in Still Picture Recording Mode.
It may take some time for Automatic White Balance to adjust.
In the Quick Start Mode, the zoom magnification becomes 1 .
If [ECONOMY] ( 36) is set to [5 MINUTES] and the unit automatically goes into Quick Start Standby Mode, close the LCD monitor and then open it again.
Quick Start Standby Mode cannot be released by the remote control. Turn the mode to OFF when powering off.
Quick power on
(Only when recording to an SD card or built- in memory)
The unit is put into recording pause approx.
1.9seconds when the mode is set to 
or 
from OFF.
Start time will not shorten if there is no SD card inserted.
Start time will be shorten if the
Change the mode to 
or 
.
1
Select SD card as a media to record from the menu. ( 33)
[MEDIA SELECT] [SD CARD]
2 Select the menu. ( 33)
[SETUP] [QUICK POWER ON] [ON]
This function’s default setting is [ON].
Depending on the recording conditions, start time may be longer than 1.9 seconds in Still Picture Recording Mode.
In the Quick Power on Mode, the zoom magnification becomes 1.
50
VQT1Z09
