How to remove the battery

When disposing of your used products, perform [RESET Wi-Fi SETTINGS] to delete personal information from this unit.

This figure describes the disposal of this unit, it is not instruction for repair. If disassembled, repair is not possible.

Disassemble after the battery runs out.

If it cannot be removed smoothly, contact Panasonic’s Service Center.

Keep disassembled parts out of reach of children.

1Open the side cover, and remove all of the 6 screws indicated in the

figure below.

Use a cross-slot screwdriver (commercially available).

2Remove the connector A of the flexible circuit board, and remove the circuit board on the front side (button side) of this unit.

4Remove the 4 screws indicated in the figure below, and remove the heatsink D.

5Remove the connector E of the camera unit, the built-in battery connector F, and the NFC flexible circuit board G, and lift up the circuit board.

3Pull out the flexible circuit board B, and pull out the speaker connector C upwards.

6Remove the battery by using a screwdriver.

 

Regarding the handling of used batteries

 

Insulate the terminals with cellophane tape or

similar.

 

Do not disassemble.

31

(ENG) SQT0251

Page 31
Image 31
Panasonic HX-A500 owner manual How to remove the battery, Remove the battery by using a screwdriver