Panasonic KX-HCM230 For Indicator Control window, Network window on, Transfers older

Operating Instructions

		About Network Camera Setup
Problem		Cause and Remedy
When forgetting	Follow the steps below.
the password to	1.	Initialize Network Camera by pressing the CLEAR SETTING
access the		button.
Setup Page.
	2.
		Reconfigure Network Camera.
Indicator does	•	Confirm that the standard AC adaptor PSLP1233 (Order No.
not light up.		PSLP1233Z) is used.
	•	Confirm that the Indicator Control is disabled. Refer to page 84
		for Indicator Control window.
Indicator is	•	Ethernet cable is not connected properly.
orange.	•	PC, Ethernet hub or broadband router is not working.
Green indicator	Internal Failure of the server or the congestion on the network
continues	traffic when using DHCP may prevent Network Camera from
blinking.	getting the IP address. Ask the network administrator or your ISP.
Orange	Orange indicator blinks when updating firmware on page 87. When
indicator	the Update Firmware failed, refer to page 119.
continues
blinking.
Red indicator	If you cannot access Network Camera, the Network Camera
continues	hardware may be defective. Call our customer call center.
blinking.
Image Transfer	•	Default Gateway and DNS server address should be set up on
on e-mail or FTP		Network window on page 54.
does not work.	•	If FTP does not work properly, ask your ISP or network
		administrator about the transferring mode of FTP server.
		[Passive Mode] or [Active Mode] is available.
	•	Select [One Time] for Login Timing when transferring images
		by FTP in short duration time.
Timer mode	Short interval of Image Buffer Frequency makes Network Camera
transfers older	transfer the older images. Set the interval long enough to transfer
images.	the images. Buffered Image screen enables you to check this
	setting.

118