Operating Instructions
4.1Network Camera Installation
Network Camera has a splash resistant body. The splash resistant body allows Network Camera to be used indoors and outdoors. Waterproof cabling is necessary for outdoor mounting. Check Network Camera operation before installing (cabling and mounting) Network Camera.
Notes
•Install Network Camera under eaves to protect it from direct sunlight. Prolonged exposure to direct sunlight or halogen light may damage the CMOS sensor.
•Use the Sunshade in any conditions.
•Do not install Network Camera in the location where sea breezes may hit the unit directly.
•Avoid laying Ethernet cable underground or stringing it in the air. Lightning may cause serious damage to Network Camera or the connected devices.
•AC adaptor is not waterproofed. Put the AC adaptor inside the outdoor power equipment near Network Camera and protect the AC adaptor from the rain. Ask the authorized electric wiring dealer.
•AC adaptor cord and Ethernet cable should be waterproofed. Do the waterproof electric wiring work.
•Do not expose the AC adaptor to the temperatures below
•Lightning can cause serious permanent damage to Network Camera. Be sure that Network Camera is grounded in accordance with local electrical codes for your specific application.
•If Network Camera is used outdoors, the Rubber Cap must be installed in the CLEAR SETTING button hole. It protects Network Camera's internal components from moisture damage. Carefully insert the Rubber Cap into the hole, gently pressing it into place using the end of the long tool. In order for it to work properly the cap must be seated correctly and fit snug.
•If Network Camera is positioned facing direct sunlight it is possible that a faint "rainbow" lens flare may be visible on the image. Sunshade acts similar to a lens shade on a
92
