1. Introduction and Installation
14 For assistance, please visit http://www.panasonic.com/help
3Load the paper, print-side up (2).
Important:
LPush and lock the plate (3) in the paper input
tray, if it is lifted.
4Adjust the recording paper guides. Pinch the front
side of the recording paper guide (4), then slide it to
match the paper size mark. Pinch the right side of
the recording paper guide (5), then slide it to adjust
the width to the size of the recording paper.
LMake sure that the recording paper is under the
paper limit mark (6), and the paper should not
be loaded over the snubbers (7).
5Insert the paper input tray to the unit, lifting the front
part of the tray. Then push it completely into the unit.
Note:
LIf the paper is not loaded correctly, re-adjust the
paper guides, or the paper may jam.
LIf the paper input tray does not close, the plate in the
paper input tray may be lifted. Push the paper and
make sure that the paper is laid flat in the paper input
tray.
Caution for the paper input tray
LDo not drop the paper input tray.
LHold the paper input tray with both hands when
removing or installing. The paper input tray
weighs approximately 2 kg (4.4 lb.) when the
recording paper is fully installed.
3
2
7
6
5
4

Approx. 2 kg (4.4 lb.)

MB271-781-PFQX2722ZA-OI-en.book Page 14 Tuesday, May 22, 2007 5:20 PM