3.8.2. Main Control Board Disassembly

(1) Remove 2 screws ( A ) and 2 screws ( B ).
(2) Remove the Connector Shield Cover.
Caution:
For KX-P7110 only, when replacing the Connector
Shield Cover, remove the Mac ID Label from the
original Connector Shield Cover and stick it on the
new Connector Shield Cover.

3.9. Fuser Drive Gear

Before handling, perform the following steps A - C :
A. Remove the Right Cover ( see Section 3.2 ).
B. Remove the Engine Control Board and Engine Board Shield Base ( see Section 3.7.1 and Section 3.7.2 ).
C. Remove the 2nd Feeder I/F Board and Main Control Board ( see Section 3.8 ).
(1) Remove 6 screws.
(2) Remove the Fuser Drive Gear Bracket.
(3) Remove the Fuser Drive Gear and Intermediate Gear.
Caution:
Be careful not to lose the plastic ring behind the
Fuser Drive Gear.

3.10. Fan Motor

Before handling, perform the following steps A - B :
A. Remove the Right and Left Covers ( see Section 3.2 ).
B. Remove the Engine Board Shield Cover ( see Section 3.7.1 ).
(1) Remove the 2 screws.
(2) Remove the Fan Motor.
(3) Disconnect connector CN 018 on the Engine Control Board.
38
KX-P7105 / KX-P7110