3.11. Gear Support Bracket, Relay Board ( A ), Motor, Drive Gear Unit and

Paper Empty Sensor Board

Before handling, perform the following steps A - C :
A. Remove the Right Cover ( see Section 3.2 ).
B. Remove the Engine Board Shield Cover ( see Section 3.7.1 ).
C. Remove the Main Board Shield Cover ( see Section 3.8.1 ).

3.11.1. Gear Support Bracket

(1) Disconnect the connector CN012 from the Engine Control
Board.
(2) Remove screw ( A ) and 4 screws ( B ).
Caution:
Screw (A) is different from screw (B). When reinstalling
the screw, return it to the original position.
(3) Remove the Gear Support Bracket and solenoid.
(4) If necessary, remove the 8 gears from the chassis.

3.11.2. Relay Board ( A ), Drive Gear Unit and Motor

(1) Disconnect the connector CN017 from the Engine Control
Board.
(2) Remove the screw (A).
(3) Remove the cable from the Drive Gear Unit.
(4) Remove the screw (A ) and 5 screws (B).
Caution:
The screw (A) differs from the screw (B). When
reinstalling the screw, return it to the original position.
(5) Remove the Drive Gear Unit.
(6) Remove the 2 screws (C).
(7) Remove the Relay Board ( A ).
39
KX-P7105 / KX-P7110