Recommended Media
Transparency:
· To avoid damaging the printer, do not use ink jet transparencies.
· Transparencies and adhesive material used on labels should be stable at 205°C ( 400°F ), the printer’s maximum temperature.
· Re-using transparencies that have been fed through the printer once ( for example, after jams or if the transparency is ejected
without being printed ) can reduce the life of the consumables and paper path components.
· When using transparencies, and if the print quality is poor, check to ensure the correct side is being printed.
Labels:
· With any label stock, the labels must completely cover the backing material.
Envelope:
It is recommended that you purchase only high quality envelopes with diagonal seams, as shown in the diagram below:
High quality envelopes have the following characteristics:
· A thin, sharply creased leading edge
· Paper weight of 90 g/m2( 24 lbs. )
· Flat, free of curls, wrinkles, nicks, etc.
Note:
Wrinkles may occur in some case, even when using high quality envelopes.

1.1.4.2. Margins and Print Area

The image ( print area ) is printed a bit smaller than the media size. 4.2 mm ( 0.17” ) is required for top, bottom and side margins.
It may be needed to adjust the print margins in the application software to match the allowable printarea.
9
KX-P7105 / KX-P7110