148
Setup from the Printer Panel and WebSetup
NOTE:
•Req. All Route and Resp. All Route are displayed only when YES is
selected in Source Routing.
Req. All Route
Yes/No [No*]
If source routing is enabled, select Yes to allow all routers on the network to
broadcast the presence of the printer to clients, enabling packets from
clients on the network to travel to the printer by any route.
Resp. All Route
Yes/No [No*]
If source routing is enabled, and Req. All Route is set to No, select Yes to
allow all routers on the network to broadcast the presence of clients to the
printer, enabling packets from clients on the network to travel to the printer
by any route.
(*=Default setting)
Network protocol setup screens are used to specify and setup TCP/IP
Ethernet, TCP/IP Tok en Ring, AppleTalk and IPX (Novell) network protocols.
NOTE:
•When exiting Setup menus, the printer will automatically restart if
changes have been made to Network Protocol settings.
Network Protocol Setup
To advance to the next screen, press the ENTER button. Select TCP/IP
Setup, AppleTalk Setup, or IPX/SPX Setup, depending on your network
connections.

A) When you select TCP/IP Setup:

TCP/IP Setup
Press the ENTER button to view TCP/IP options.
Enable TCP/IP?
Yes/No [No*]
Select Yes if you have a TCP/IP network connected to the printer over
Ethernet cabling.
Ethernet IP Address or Token Ring IP Address
[127.000.000.001*]
Use this option to assign the printer an Ethernet or Token Ring IP address.
Network Protocol Setup