Chapter 6
145
Setup from the Printer Panel and WebSetup
This chapter describes how to configure the printer’s Setup options. The
settings you specify in Setup determine user access to the printer, printing
defaults applied to jobs, and general system settings. Some Setup options
are specified during an initial Setup from the printer panel; others must be
set later from Fiery WebSetup.

Initial Setup from the printer panel

Initial Setup for network printing must be performed using the printer panel.
After the initial Setup is complete, you must finish configuring Setup options
using Fiery WebSetup (see page 151). Some options set from the printer
panel can also be modified using Fiery WebSetup.
The general steps for performing Setup from the printer panel are:
•Specify parallel port settings (page 146).
•Specify network port settings (page 146).
•Specify network protocol settings (page 148).
Before you change any Setup options, it’s a good idea to print the current
configuration settings, in case you need to restore these settings later. For
information on printing a configuration page, see “Printing pages from the
printer panel” on page 202.
Use the following procedure to access the Parallel Port Setup, Network Port
Setup, and Network Protocol Setup menus from the printer panel.
To access Setup menus from the printer panel:
1
Turn on the printer.
Wait until “Ready” or “Ready(Sleep)” is displayed.
2
Press the MENU/EXIT button.
3
To advance through the options, press the
▲ /CONTINUE button; to return to previous options,
press the ⁄ /CANCEL button.
4
To select an option, press the ENTER button.
Repeat steps 3 and 4 to continue accessing other options.
5
To exit the Setup menus at any time, press the MENU/
EXIT button.