60
Setup
If a SCSI-2 board has been installed in your computer, be sure it is
compatible (see “SCSI interface” on page 298). If it is not installed, be sure
to install only a recommended SCSI-2 board (see page 29).
If you do not have a SCSI cable, you will need to purchase one from your
local computer store or dealer (see “SCSI interface” on page 298).
Recommendation for connecting DCIS:
•We recommend you to connect your DCIS with only one SCSI device.
•For a SCSI chain with up to three SCSI-2 (FAST SCSI) devices
connected, the total length of the SCSI cables must be less than 3 m
(9.8 ft.).
•Use shielded cables for SCSI-2 (FAST SCSI).
NOTE:
•Although a SCSI chain may exceed the recommended length and still
operate we cannot guarantee this operation.
1
Make sure the computer, scanner, printer and the other
connected peripheral devices are turned off.
2
Connect the SCSI cable (not provided) to the
computer’s SCSI connector and to the scanner’s SCSI
connector A or B.
The SCSI-2 board must be installed in the computer.
If you do not have a SCSI-2 board or a SCSI cable, you will need to
purchase one from your local computer store or dealer (see “SCSI
interface” on page 298).
Digital Color Imaging System (DCIS) standard system
SCSI connector
A or B
SCSI cable
Computer’s
SCSI connector