253
Care and Maintenance
Press Enter to
Initialize Disk
Press the ENTER button to initialize a new
hard disk. This message will also appear if
the hard disk has malfunctioned, or if the
hard disk is the incorrect type. If this error
appears after cycling power to the printer,
contact an authorized service
representative.
Printing
Configuration
Printer is printing the Configuration page.
Printing
Font List
Printer is printing the Font List page.
Printing
Test Page
Printer is printing the Test Page.
Processing Printer is receiving or processing a print job.
PS Memory Full Not enough memory to finish printing.
Change printing resolution to 600 x 600 dpi if
you selected higher resolution.
or
Install additional memory in the printer.
PS Memory Full
Stored Data Lost
Not enough memory to finish printing.
Change printing resolution to 600 x 600 dpi if
you selected higher resolution.
or
Install additional memory in the printer.
RAM Test Failure
Cycle Power
Cycle Power. If printer does not function
normally, call for service.
Scan Buffer Error
Cycle Power
Cycle Power. If printer does not function
normally, call for service.
Service (%s)
Cycle Power
Firmware error. Contact an authorized
service representative.
TEST FAILED
UP/DOWN CANCEL
Initial hardware test failed.
Call for service.
Transfer
wearing out
Transfer unit will need to be replaced soon.
Transparency Tray
Not installed
Install transparency tray.
Upper Left side door
Open
Close Left side door.
Message Corrective Action/Additional Information