-..........until the desired operator number (1 or 2) appears
b
.-.......... AB= mr[ :
to assign extension (Jack no. 01) for Operator use
m’k[ : to assign extension (Jack no. 32) for Operator use
default ...... Nothing is stored
Description Up to 2 of any extensions can be selected as the
operator extensions.
00 can be dialed to call operator 1, and 01 can be
dialed to call operator 2. “CO Mode (Direct In Line)
Assignment (on page 3-57)” can be used to program
all incoming calls to be answered by the operator.
Press the MEMORY button. 5.
6.
7.
The LCD will stop blinking.
Repeat steps 3 to 5, to program the jack
number which is set the operator 2.
To return to the initial program mode, press
the END button.
Programming To clear the jack number which is set
1.
Dial (03). operator, press the CLEAR button at step 4.
“Operator Ext” will be displayed.
2. Press the NEXT button.
“Operate NO?--” will be displayed.
3. Press the NEXT button.
“OPT1 : Disable” will be displayed and
“Disable” will blink.
4. Dial the jack number which is set the operator 1.
l
When you dial (01)
, “OPT1 : Jack-01” will be displayed.
Programming Table See
page 7-3.
Conditions 3-9