Before Use
ªUsing the Remote Controller
1Direct the Remote Controller at the Remote Control Sensor (31) of the Movie Camera and press an appropriate button.
Power Supply
ªUsing the AC Adaptor
15˚ |
|
15˚ | (31) |
| |
15˚ | 15˚ |
|
≥Distance from the Movie Camera: Within approximately 5 metres
≥Angle: Within approximately 15o in the vertical and horizontal directions from the central axis
≥The above operating ranges are for indoor use. Outdoors or under strong light, the Movie Camera may not operate properly even within the above ranges.
Selecting Remote Controller Modes
When 2 Movie Cameras are used simultaneously, they can be operated individually by selecting different Remote Controller Modes.
≥If the Remote Controller Mode of the Movie Camera and that of the Remote Controller do not match, [REMOTE] Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the [INITIAL]
Setup on the Remote Controller:
| 6 | 1 | 5 |
|
2 | STILL ADV PAUSE STILL ADV | 1 | ||
E | ; | D | ||
| INDEX | STOP | INDEX | P.B. ZOOM |
| K | ∫ | L |
|
SELECT
[VCR1]:
Press the [D] Button and [∫] Button simultaneously. 1
[VCR2]:
Press the [E] Button and [∫] Button simultaneously. 2
≥When the battery in the Remote Controller is replaced, the mode is automatically reset to [VCR1] Mode.
1
1 2
3
1Connect the DC Input Lead to the [DC/C.C.IN] Socket on the Movie Camera.
2Connect the DC Input Lead to the AC Adaptor.
3Connect the AC Mains Lead to the AC Adaptor and the AC mains socket.
≥The AC Mains Lead’s outlet plug does not fit
entirely into the AC Adaptor socket. A gap will remain as shown 1.
≥Before connecting or disconnecting the power supply, set the [OFF/ON] Switch on the Movie Camera to [OFF] and make sure that Power Lamp is not lit.
ªUsing the Battery
Before use, fully charge the Battery.
≥We recommend using Panasonic’s Battery. ≥We cannot guarantee the quality of this Movie
Camera when batteries of other companies are used.
1Attach the Battery to the AC Adaptor and charge it.
≥Since the Battery will not be charged when the DC Input Lead is connected to the AC Adaptor, disconnect it from the AC Adaptor. ≥The [POWER] Lamp and [CHARGE] Lamp
lights up, and charging starts. ≥When the [CHARGE] Lamp goes off,
charging is completed.
